Download  Print this page

Kawasaki KZ1300-A1 Quick Reference Manual Page 62

Hide thumbs

Advertisement

DISASSEMBLY--ENGINE INSTALLED
eRemove the circlip, and pull the
impeller
CD
off the
water pump shaft.
A.
Impeller
B. Circlip
eRemove the mechanical seal retainer screws (2), and
turn 6 mm diameter bolts or
screws
(with 1.0 mm
pitch threads) about 30 mm long evenly
into
the
threaded holes provided in the retainer
CD
to pull the
retainer from the cylinder block.
~ =c:a;:~e ':!:~a~~c:~a~h;u~~~~n:~~~~
tion.
A. Mechanical Seal Retainer
B.
Sealing Surface
ePress out the mechanical seal
CD
by using the bearing
driver holder (special tool).
A. Bearing Driver Holder (57001·139)
ePull out the sealing seat
<D
and rubber seal
CD
from
the
impeller.
It will be removed easily by hand.
Water Pump. Mechanical Seal
1.
Circlip
5.
Mechanical Seal
2.
Impeller
6.
Screw
3.
Rubber Seal
7.
Retainer
4.
Sealing Seat
Installation:
eApply coolant to the surfaces of the rubber seal and
sealing seat, and install the rubber seal and sealing seat
into the impeller by pressing them by hand until the
seat stops at the bottom of the hole.
A. Sealing Seat
C.
Apply coolant
to
the
surfaces.
B. Rubber Seal
eApply a liquid gasket compound to the mating surface
of the mechanical seal body (Fig. E66), and press
it
into the retainer using the front fork oil seal driver
(special tool). Press it until the flange of the mechani-
cal seal body comes in contact with the
retainer.
62

Advertisement

Table of Contents

This manual is also suitable for:

Kz1300-a2

Comments to this Manuals

Symbols: 0
Latest comments: