Download  Print this page

Kawasaki KZ1300-A1 Quick Reference Manual Page 256

Hide thumbs

Advertisement

MAINTENENCE--ELECTRICAL
HAZARD WARNING CIRCUIT
A wiring diagram of the hazard warning circuit
IS
shown in Fig. K65. When
the
ignition switch
is in
the
On or Park position, and the hazard switch is
turned
on;
a ground
is
provided
for
the circuit so
current can flow.
The
current
flows intermittently by
the
working of the
hazard relay,
then
all the
turn
signals will
flash
on and
off.
Since the hazard
relay
is designed to operate correct-
ly only when all turn signals and
the
turn signal indicator
light are properly connected
in
the circuit,
trouble
may
result
from a burned out bulb, a bulb of incorrect
wattage, loose wiring, as well as
from a
defect
in the
relay
itself.
Hazard Warning Circuit
Left Turn
Signal Lights
Indicator Lights
Green
)l
Gray
LJ
0 - - - - - - - - ' - - - - -
Hazard
Switch
Orange/Green
+
Battery
Fuse
Testing the hazard warning circuit
Right Turn
Signal Lights
Hazard Relay
Orange/Green
Before testing the hazard warning
circuit,
check the
turn signal operation.
(1 )Wiring Inspection:
-Remove the fuel tank, and disconnect the 6-pin
connector from the left switch housing.
-Measure the voltage at the 6-pin connector as shown
in Table K22.
A. 6-pin Connector from the Left Switch Housing
Table K22
Hazard Warning Circuit Wiring Inspection
Meter
Connections
Ignition
Reading
Switch
On or
Battery
20V
Meter (+)
~
Park
DC
Orange/Green
Position
Voltage
Meter (-)
~
Ground
Off
or
Lock
OV
-I
f anyone
of the meter readings
shows
an
improper
value, check
the ignition switch
(Pg.
248),
connec-
tions and
orange lead between the ignition
switch
and the
6-pin connector, and the hazard relay. If
the
meter reading shows
the
wiring good,
check
the
hazard
switch.
(2)Hazard Switch Inspection
:
-Table K23 shows the internal connections of the
hazard switch. To check the switch, disconnect the
3-pin and 6-pin connectors, and use an ohmmeter
to
verify
that there is continuity between all the
connections that are listed in the table.
If the
switch has an open circuit or short, the switch
must be replaced.
Table K23
Hazard Switch Connections
Color
Green
Orange/G
reen
Gray
Off
On
*
Check the switch connections at the 3-pin and 6-pin
connectors from the left switch housing.
256

Advertisement

Table of Contents

This manual is also suitable for:

Kz1300-a2

Comments to this Manuals

Symbols: 0
Latest comments: