Download  Print this page

Kawasaki KZ1300-A1 Quick Reference Manual Page 255

Hide thumbs

Advertisement

MAINTENENCE--ELECTRICAL
repair. The contact surfaces may be cleaned, but no
internal parts are available for replacement.
If any
parts are not repairable, the switch must
be
replaced
as a unit.
A. 9-pin, &-pin, end 3-pin Connectors from
the Left Switch Houling
Tabl. K19
Selector Switch Connections-
Lead Color
Brown
Yellow
Switch
Off
Position
On
-
*Check connections at the 3-pin and 6-pin connectors.
Tabl. K20
Turn Signal Switch Connections-
Gray Orange Green
Red/
Ground
White/ Blue/
White
Red
White
R
N
L
*Check connections at the 9-pin connectors.
Tabl. K21
Wiring Inspection
Meter Range
Connections*
Ignition**
Switch
Yellow,
on
20V
DC
Meter
(+)
-+
Blue/White
off
Meter
(+)
-+
White/Red
on
off
*
**
Connect the meter negative (-) lead to ground.
Turn the main switch to the on position.
Next check that the solenoid operates properly when
it receives a pulse from the control unit.
eSwitch the turn signal switch to either side, connect a
wire
to
the positive
(+)
side of the battery and touch
it to the white/green lead in the 9-pin connector
momentarily. At this time the solenoid should return
the turn signal switch to the off position. If
it
does not
do this for both right and left positions, replace the
switch assembly.
~
:tte' 7 ;r::r::.
~:rba':: ~:: ~
:;
seconds, as
it
could bum out the IOlenold.
Wiring inspection
econnect all the
leads
and connectors.
e
Puli off the right side cover, remove the mounting bolts,
and pull out the IC igniter and regulator/rectifier.
e
Measure the voltage at the 6-pin connector from the
turn signal control unit as shown in Table K21.
A. &-pin Connector
e
lf anyone of the meter readings shows an improper
value, check the wiring and connections of the turn
signal switch, distance sensor, and turn signal control
unit.
Replace the turn signal control unit if all
of them turn out good.
NOTE:
The turn signal control unit is located beneath
the battery tray.
Selector Switch
Turn Signal Switch
Reading
Position
Position
on
Any (R, L, Neu.)
Battery voltage
off
Any
OV
on
Ror L
Battery voltage
off
Neutral
OV
255

Advertisement

Table of Contents

This manual is also suitable for:

Kz1300-a2

Comments to this Manuals

Symbols: 0
Latest comments: