Download  Print this page

Kawasaki KZ1300-A1 Quick Reference Manual Page 130

Hide thumbs

Advertisement

DISASSEMBLY -- CHASSIS
Rear Hub
3. Use the bearing driver and the bearing driver holder
(special tools) to install the wheel bearings.
Install
the left bearing first. The shield of each bearing must
face outside.
A. Bearing Driver (57001-140)
B.
Holder (57001-139)
4. Put the distance collar into the hub so that the flange
on the collar is on the right side, and install the right
bearing.
H
)
l. Axle Nut
8. Distance Collar
2. Wheel Cap
9. Ball Bearing
3. Disc
10. Bolt
4. Grease Seal
1l. Rubber Damper
5. Circlip
12. Collar
6. Ball Bearing
13. Cap
7. Cast Wheel
14.
Rear Axle
5. Install the grease seal using the bearing driver and
the bearing driver holder (special tools: PIN 57001-
296, 57001-139).
6. Tighten the disc mounting bolts (7) to 2.3 kg-m (16.5
ft-Ibs) of torque.
7.
After installing the disc or the hub, check disc runout
(Pg.223).
REAR DISC BRAKE, REAR BRAKE
LIGHT SWITCH
Removal, installation, disassembly, and assembly of
the rear disc brake are divided as follows:
Pad Replacement
Caliper Disassembly
Caliper Assembly
Master Cylinder and Rear Brake Light Switch Removal
Master Cylinder Installation Notes
Master Cylinder Disassembly
Master Cylinder Assembly
NOTES:
1. Disc removal and disc installation are covered in
the rear hub disassembly and assembly sections (See
above).
130

Advertisement

Table of Contents

This manual is also suitable for:

Kz1300-a2

Comments to this Manuals

Symbols: 0
Latest comments: