OISASSEMBL Y -- CHASSIS
Front Master Cylinder
- Pg. 123). Apply brake fluid to the parts removed
and to the inner wall of the cylinder.
2. Be sure that the piston stop
is between the piston
and dust seal
A. Dust Seal
C. Piston Stop
Brake Hose Replacement:
ePump the brake fluid out of the line as explained in
the Maintenance Section -
Changing the brake fluid
eRemove the banjo bolts at the hose joint and at the
caliper or master cylinder (depending on the hose), and
8. Pivot Bolt
11. Master Cylinder Body
1. Dust Cover
17. Piston Stop
18. Dust Seal
remove the brake hose. There is a flat washer on each
side of the hose
elnstall a new flat washer on each side of the brake hose
fittings and connect the new brake hose to the hose
joint and the caliper or master cylinder.
eBe sure that the metal pipe is properly fitted into the
U-shaped notch in the hose joint and tighten the banjo
bolts to the specified torque.
A. Metal Pi pe
B. Hose Joint
eFill the reservoir with fresh brake fluid, and bleed the
brake line (Pg. 221 ).