OISASSEMBL Y -- CHASSIS
Bleed Valve Cap
7. Fluid Seal
10. Pad A
Caliper Holder Shaft
12. Dust Cover
eClean the caliper parts with brake fluid or alcohol
Caliper Dust Seal
(See CAUTION -
eFit a new fluid seal.in place inside the cylinder.
NOTE: Whenever the fluid seal is removed, it should
be replaced with a new
eApply brake fluid to the outside of the piston and the
fluid seal, and push the piston into the cylinder by
Take care that neither the cylinder nor the
piston skirt get scratched.
elnstall the dust seal around the dust seal
that the dust seal is properly fitted into the groove in
the piston and on the dust seal stop.
eApply a thin coat of PBC (Poly Butyl Cuprysil) grease
to the caliper holder shafts and the holder holes. (PBC
grease is a special high temperature, water-resistant
NOTE: Replace the dust covers and rubber friction
boots if they were damaged.
14. Metal Plate
16. Mounting Screw
Caliper Mounting Bolt