Download  Print this page

Kawasaki KZ1300-A1 Quick Reference Manual Page 123

Hide thumbs

Advertisement

DISASSEMBLY -- CHASSIS
eRemove the wheel cap
CD
and holding plate
®
.
Re-
move both discs
@
by unscrewing the mounting bolts
CD
(14).
eRemove the circlip
CD
on the left side, and remove the
speedometer gear drive
CD
.
ePry out the grease seal
CD
on the right side, and remove
the circlip
CD.
A.
Grease Seal
elnsert a metal rod from the left
side,
tap the inner
race of the right side ball bearing
Q)
evenly, and remove
the ball
bearing.
The distance collar
@
will come out
when the bearing is removed.
Ball Bearing Removal
eTap out the other ball bearing Q).
Front Hub Assembly Notes:
1. Inspect the bearings, and replace if necessary (Pg.
216).
2.
Before installing the wheel
bearings,
blow any dirt
or foreign particles out of the hub with compressed
air. Lubricate the ball bearings
(Pg.
216).
3.
Install the ball bearings using the bearing driver and
the bearing driver holder (special tools) with the
shield of each bearing facing
outside.
Install the
left bearing
fi
rst.
A. Bearing Driver Holder
(57001-139)
B. Bearing Driver
(57001-290)
4.
Put the distance collar in the hub so that the flange of
the collar is on the left side, then install the right
bearing.
5. Install the grease seal using the bearing driver and
the bearing driver holder (special tools: PIN 57001-
296,
57001-139).
6. Tighten the disc mounting bolts (14) to 2.3 kg-m
(16.5 ft-Ibs) of
torque.
7. After installing the disc on the hub, check disc run-
out
(Pg.
223).
FRONT DISC BRAKE
Removal, installation, disassembly, and assembly of
the front disc brake is divided as follows:
Pad Replacement
Caliper Removal
Caliper Installation Notes
Caliper Disassembly
Caliper Assembly
Master Cylinder Removal
Master Cylinder Installation Notes
Master Cylinder Disassembly
Master Cylinder Assembly Notes
Brake Hose Replacement
NOTE: Disc removal and installation are covered in
front hub disassembly and front hub assembly sections
(Pgs.122-123).
Before working on the disc brake, take note of the
following:
~
1.
~:h:~.IYord~7h~r:~:0:0~i~~riS~:::~:~
brake parts (except disc pads and discs). Do not use
any other fluid for cleaning these parts. Gasoline,
motor oil, or any other petroleum distillate
will
cause
123

Advertisement

Table of Contents

This manual is also suitable for:

Kz1300-a2

Comments to this Manuals

Symbols: 0
Latest comments: