NEC Electra Elite IPK II Pc Programming Manual page 42

Electra Elite IPK II
Standard View
To assign which extensions and trunks use the Route Table Entry, complete the
following:
5. Select a Route Table entry and select a Night Mode.
6. Select which extensions, during this Night Mode, use the Route Table entry
via the Trunk Access Code.
7. Select which extensions, during this Night Mode, use the Route Table entry
via the Alternate Trunk Access Code.
8. Select which trunks, during this Night Mode, use the Route Table entry.
Trunk Group – Trunks
Lists which trunks are members of the Trunk Group. These settings are linked
with 14-05-01.
Trunk Group – Priority
J Lists the priority of trunks within the Trunk Group.
These settings are linked with 14-05-02.
When a trunk is selected as part of the Trunk Group it will automatically appear in
the priority list (the list to the bottom of the Trunk Group list). The priority of the
selected trunk can be modified by the following key combinations:
Shift + Up ArrowIncrease priority by 1
J Shift + Down Arrow
J
Shift + Page Up
J
Shift + Page Down
J Shift + Home
J
Shift + End
Route Table
Defines routes with 4 destinations for transferring calls. Each destination can be
either a Trunk Group or another Route Table entry. Destinations are prioritized
1~4 with 1 being the highest and 4 being the lowest. These settings are linked
with 14-06.
Decrease priority by 1
Increase priority by one page
Decrease priority by one page
Make highest priority
Make lowest priority
Document Revision 1
31