Sony DREAM MACHINE ICF-CD7000 Operating Instructions

2-899-053-21(1)
FM/AM CD Clock Radio
Operating Instructions
Owner's Record
The model number and the serial number are located on the bottom.
Record the serial number in the space provided below. Refer to them whenever you call
upon your Sony dealer regarding this product.
Model No. ICF-CD7000
Serial No.
No Power No problem is a trademark of Sony Corporation.
Dream Machine is a trademark of Sony Corporation.
ICF-CD7000
© 2007 Sony Corporation Printed in China
This unit includes a preinstalled Sony Lithium battery (CR2032) as back-up power source for the clock, which is preset
to EST (Eastern Standard Time) at the factory. And this battery is considered part of the product.
For customers who purchased this product in the Features
USA
Please register this product on line at
 Illumination (High/Low/Off)
http:/ / www.sony.com/productregistration.
 Built-in audio cable for digital music players
Proper registration will enable us to send you
 Built-in CD player with CD-R/RW playback
periodic mailings about new products, services,
function
and other important announcements.
 FM/AM 2-band digital tuner
Registering your product will also allow us to
 15 Station Presets (10 FM, 5 AM)
contact you in the unlikely event that the product
 Automatic Time/Daylight Saving Time Setting
needs adjustment or modification. Thank you.
 No Power No Problem Alarm System
 Triple time display: A main display for the clock and
WARNING
two sub-displays for the alarms
 Nap Timer (Count Down Timer)
To reduce the risk of fire or electric shock, do not
 Extendable Snooze time from 10 to 60 min
expose this apparatus to rain or moisture.
To avoid electrical shock, do not open the cabinet.
Refer servicing to qualified personnel only.
Precautions
Do not install the appliance in a confined space, such
as a bookcase or built-in cabinet.
 Use the power source specified in "Specifications" to
To reduce the risk of fire or electric shock, do not
operate the unit.
place objects filled with liquids, such as vases, on the
 The name plate indicating operating voltage, etc. is
apparatus.
located on the bottom of the unit.
Connect the apparatus to an easily accessible AC
 To disconnect the power cord (mains lead), pull it
outlet. Should you notice an abnormality in the
out by the plug, not the cord.
apparatus, disconnect the main plug from the AC
 Do not carry the unit by the FM wire antenna and Do not carry the unit by the FM wire antenna and
outlet immediately.
the AC power cord.
 Do not leave the unit in a location near a heat source
such as a radiator or air duct, or in a place subject to
direct sunlight, excessive dust, mechanical vibration,
or shock.
 Allow adequate air circulation to prevent internal heat
build-up. Do not place the unit on a surface (a rug,
blanket, etc.) or near materials that might block the
ventilation holes such as a curtain.
 Should any solid object or liquid fall into the unit,
unplug the unit and have it checked by a qualified
personnel before operating it any further.
 When the casing becomes soiled, clean it with a soft
cloth dampened with mild detergent solution. Never
This symbol is intended to alert the user
use abrasive cleansers or chemical solvents, as they
to the presence of uninsulated "dangerous
may mar the casing.
voltage" within the product's enclosure that
may be of sufficient magnitude to constitute If you have any questions or problems
a risk of electric shock to persons. concerning your unit, please consult your nearest
Sony dealer.
This symbol is intended to alert the user to
the presence of important operating and
Troubleshooting
maintenance (servicing) instructions in the
literature accompanying the appliance.
Should the problem persists after you have made the
 The graphical symbols are at the bottom of the unit.
following checks, consult your nearest Sony dealer.
INFORMATION
The clock flashes "AM 12:00" due to a power
interruption.
This equipment has been tested and found to
 The battery is low. Replace the battery. Remove the
comply with the limits for a Class B digital device,
old battery and install a new one.
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against
The CD, radio or buzzer alarm does not sound at
harmful interference in a residential installation.
the preset alarm time.
This equipment generates, uses and can radiate radio
 Hasn't "ALARM A" or "ALARM B" in the display
frequency energy and, if not installed and used in
gone out?
accordance with the instructions, may cause harmful
The CD or radio alarm is activated but no sound
interference to radio communications. However, there
comes on at the preset alarm time.
is no guarantee that interference will not occur in a
 Has VOLUME been adjusted ?
particular installation. If this equipment does cause
harmful interference to radio or television reception,
The CD player does not operate.
which can be determined by turning the equipment
 Did you close the CD compartment lid?
off and on, the user is encouraged to try to correct the
 Did you insert the disc correctly?
interference by one or more of the following measures:
The disc should be inserted with the label
— Reorient or relocate the receiving antenna.
side up.
— Increase the separation between the equipment
 Dusty or defective disc — Clean the disc with an
and receiver.
optional cleaning cloth. Wipe the disc from the
— Connect the equipment into an outlet on a
center out.
circuit different from that to which the receiver is
 Take out the CD and leave the CD compartment
connected.
open for about an hour to allow condensation to
— Consult the dealer or an experienced radio/ TV
evaporate.
technician for help.
Sporadic loss of sound during CD operation.
 Dusty or defective disc — Clean or replace the disc.
You are cautioned that any changes or
 Excessively high volume — Reduce the volume.
modifications not expressly approved in this
 Strong vibration.
manual could void your authority to operate this
equipment. No sound comes from the speakers.
 Has VOLUME been adjusted ?
CAUTION
The use of optical instruments with this product
will increase eye hazard.
WARNING
Battery may explode if mistreated.
Do not recharge, disassemble or dispose of in fire.
For the state of California, USA only
Perchlorate Material – special handling may apply, See
www.dtsc.ca.gov/hazardouswaste/perchlorate
Perchlorate Material: Lithium battery contains
perchlorate
Specifications
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC
DISTORTION
With 8–ohm loads, both channels driven from
150 – 10 000 Hz; rated 0.8 W per channel-minimum
RMS power, with no more than 10% total harmonic
distortion in AC operation.
CD player section
System: Compact disc digital audio system
Laser diode properties:
Material: GaAlAs
Wavelength: 785 – 800 nm
Emission duration: Continuous
Laser output: Less than 44.6 µW
(This output is the value measured at a distance of
about 200 mm from the objective lens surface on
an optical pick-up block with a 7-mm aperture.)
Number of channels: 2
Frequency response: 20 – 20 000 Hz +1 dB
–2
Wow and flutter: Below measurable limit
Radio section
Frequency range:
FM: 87.5 – 108 MHz
AM: 530 – 1 710 kHz
Antennas:
FM: FM wire antenna
AM: Built-in ferrite bar antenna
General
Time display: 12-hour system
Speaker: 50 mm (2 inches) diam., 8 Ω, cone type (2)
Input: Built-in audio cable with stereo-mini plug (1):
minimum input level 245mV, impedance 47 kΩ
Power outputs:
1 W + 1 W (at 8 Ω, 10% harmonic distortion)
Power requirements: 120 V AC, 60 Hz
For power backup: 3 V DC, one CR2032 battery
Dimensions:
Approx. 170  136  204 mm (w/h/d)
 5  8
(Approx. 6 3 / 3 / 1 / inches) incl.
4 8 8
projecting parts and controls
Mass:
Approx. 1 700 g (3 lb 12 oz) incl. CR2032 battery
Design and specifications are subject to change
without notice.