Changing The Battery - Schaudt Electroblock EBL 211 Operating Instructions Manual

3.2

Changing the battery

9110476 BA / EN
Operating Instructions Electroblock EBL 211
Changing the battery
ATTENTION!
Y
Use of incorrect battery types or incorrectly rated batteries.
Damage to the battery or devices connected to the electroblock:
Batteries may only be changed by qualified personnel.
F
Follow the battery manufacturer's instructions.
F
Only use the electroblock to connect to 12V power supplies with re-
F
chargeable 6-cell lead-gel or AGM batteries. Do not use any unsuita-
ble battery types.
Normally only batteries of the same type and capacity should be used,
Y
i.e. the same as those installed by the manufacturer.
Electrically isolate the battery from the electroblock. For this, activate the
"
battery cut-out (refer also to Section 3.4).
Remove "+ solar cell" connector on the solar charge regulator (if availa-
"
ble).
Isolate the electroblock from the mains voltage (230V AC).
"
Replace the battery.
"
After changing the battery, recheck which type of battery has been inser-
"
ted.
DANGER!
Y
Incorrect setting of the battery selector switch.
Risk of explosion due to build up of explosive gases:
Move the battery selector switch to the correct position
F
ATTENTION!
Y
Incorrect setting of the battery selector switch.
Damage to the battery.
Move the battery selector switch to the correct position
F
Disconnect the electroblock from the mains before adjusting the battery
"
selector switch.
Y
However, suitability must be checked on a case-by-case basis using the
specifications from the battery manufacturer and the charging parame-
ters of the electroblock.
The charging parameters are specified in Section 5.2.
Fig. 1 Battery selector switch
Date: 22.01.2016
1
5