Changing The Battery - Schaudt Electroblock EBL 30 Instruction Manual

Hide thumbs

Advertisement

Instruction Manual for Electroblock EBL 30 / EBL 30 with OVP

Changing the battery

Starting up
the system
4
3.2
Changing the battery
ATTENTION!
Y
Use of incorrect battery types or incorrectly rated batteries.
Damage to the battery or devices connected to the electroblock:
Batteries may only be changed by qualified personnel.
F
Follow the battery manufacturer's instructions.
F
Only use the electroblock to connect to 12V power supplies with re-
F
chargeable 6-cell lead-gel or AGM batteries. Do not use any unsuita-
ble battery types.
Normally only batteries of the same type and capacity should be used,
Y
i.e. the same as those installed by the manufacturer.
Electrically isolate the battery from the electroblock. For this, switch off
"
the battery separation switch on the EBL 30 electroblock (refer also to
Section 3.4).
Replace the battery.
"
After changing the battery, recheck which type of battery has been inser-
"
ted.
DANGER!
Y
Incorrect setting of the battery selector switch.
Risk of explosion due to build up of explosive gases:
Move the battery selector switch to the correct position.
F
Disconnect the electroblock from the mains before adjusting the battery
"
selector switch.
Fig. 1
Battery selector switch
Move the battery selector switch (Fig. 1, Pos. 1) to the correct position
"
using a thin object (e.g. a ballpoint pen):
Lead-gel battery: Move the battery selector switch to "Gel".
F
AGM battery: Move the battery selector switch to "AGM".
F
Start up the system as described in Section 3.1.
"
Date: 15.10.2018
1
8110305 BA / EN

Hide quick links:

Advertisement

loading

This manual is also suitable for:

Electroblock ebl 30 with ovp

Table of Contents