Environmental Parameters - Schaudt Electroblock EBL 30 Instruction Manual

Instruction Manual for Electroblock EBL 30 / EBL 30 with OVP
Battery charging via
mains connector
Battery charging of the
starter battery
IUoU curve
Interrupting voltage for
EBL 30 with OVP
Operating temperature
Storage temperature
Humidity
10
Leisure battery
Battery selector
switch setting
Charging curve
Final charge voltage
Charge current
Voltage for float charge 13,7 V with automatic
Starter battery
Charging current float charge
Charging voltage
New charge cycle
Switchover to main charging
Lead-gel:14.4V
AGM:
Lead-gel:13.7V
AGM:
Fig. 3 Charging voltage curve with electroblock EBL 30
I Main charge with maximum 18 A charging current, electronically limi-
ted, up to final charging voltage. Start of charge also for completely
discharged batteries.
Uo Automatic switchover to full charge with constant 14.4 V (lead-gel) or
14.7 V (AGM). The duration of the full charge phase is based on the
battery type and is set on the device.
U Automatic changeover to compensation charge with constant 13.7 V. In
the compensation charge phase, the voltage at the output of the char-
ging module is constant.
Start of a new charging cycle by switching over to main charge, if the battery
voltage falls below 13.7 V for more than 5 seconds when loaded. Start of
charge also for completely discharged batteries. The internal charge module
can also be operated without leisure battery.
Overvoltage: Approx. 265 V
This values applies for distortion-free sinusoidal voltage.
5.3

Environmental parameters

-20 C to +45 C
-20 C to +70 C
Operation in dry environment only
CE CE mark
lead-gel
IUoU
14,4 V / 16 h
18 A
switchover
max. 6 A
typ. U
for battery voltage < 13.7 V
with approx. 5 seconds delay
U
charge
V
Main charge
I
14.7 V
13.7V

eff.
Date: 15.10.2018
AGM
IUoU
14,7 V / 4 h
18 A
13,7 V with automatic
switchover
-- 0.2 V
Wbat
Full charge Trickle charge
Uo U
16 h for lead-gel
4 h for AGM
Time
8110305 BA / EN