Kenmore 111.7303 Series Use & Care Manual page 13

NOTE: Removing the doors is always recommended when it is necessary to move the refrigerator through a narrow
opening. If it is necessary to remove the handles, follow the directions below.
HOW TO REMOVE FREEZER DRAWER HANDLE
NOTE: Handle appearance may vary from the
illustrations on this page.
Removing Freezer Drawer Handle
Use a 2.5 mm hex key to loosen the set screw
located on the lower left end of the handle far
enough to pull the handle free from the underlying
mounting bolt. Carefully slide the handle to the
left to free the right end of the handle from its
mounting bolt.
HOW TO REPLACE FREEZER DRAWER HANDLE
NOTE: Handle appearance may vary from the
illustrations on this page.
Replacing Freezer Drawer Handle
Place the right end of the handle over the mounting
bolt on the right side of the freezer drawer and
carefully slide handle to the right until it stops.
Lower the left end of the handle over the left side
mounting bolt. Use a 2.5 mm hex key to tighten the
set screw to secure the handle in place.
NOTE: If the handle mounting fasteners need to be WARNING
tightened or removed, use a ¼ in. Allen wrench.
When assembling or disassembling the handles:
• Grasp the handle firmly to ensure it will not drop or
cause injury.
• Prevent the handle from swinging toward nearby
people or animals.
• Insert the handle footprints over the door mounting
fasteners and tighten the hex screws to fix the handle
in place.
• Check for any gap between the door and handle after
the handle is fixed in place.
F706-10( )(Kenmore).indd 13
REFRIGERATOR INSTALLATION
13
Mounting Bolt
2019-03-04 10:40:23