Sony TRINITRON BVM-20M4DE Operation Manual page 15

!¡USER COPY menu
Store the factory setting of D65 or D93 as the value for
USER mode.
!™COLOR SYSTEM DISPLAY menu
Select the period of displaying the color system of the
current input signals. When AUTO is selected, the
color system type being used appears on the screen
each time you change the signal input.
!£358 TRAP FILTER menu
Color spill or color noise may be eliminated if you
select ON (NTSC signal only).
Normally select OFF.
!¢SUB CONTROL menu
Select an item (CONTRAST, BRIGHT, CHROMA
and PHASE controls on the front panel) to finely
adjust on the SUB CONTROL screen (!∞).
!∞SUB CONTROL screen
Finely adjust the selected item on the SUB CONTROL
menu (!¢). Each control (CONTRAST, BRIGHT,
CHROMA and PHASE control) has a click position at
the center of its adjustment range. You can adjust the
setting of the click position with this feature.
!§USER PRESET menu
If you select ON on this menu, the REMOTE indicator
lights up and the controls on the front panel do not
work. The monitor operates with the user preset
settings.
To adjust the user preset settings, select the PRESET
ADJUST menu (!¶).
!¶PRESET ADJUST menu
You can preset the BRIGHT, CHROMA, PHASE,
CONTRAST, VOLUME, and APERTURE controls to
a desired level and can use these settings by selecting
ON on the USER PRESET menu (!§).
!•PRESET ADJUST screen
Adjust the selected item (BRIGHT, CHROMA,
PHASE, CONTRAST, VOLUME, and APERTURE
control) on the PRESET ADJUST menu (!¶).
!ªV HOLD screen
Adjust the vertical hold if the picture rolls vertically.
Note
When you cannot read the display, select the input that
is not connected.
@ºCOMPONENT LEVEL menu
Select the component level from among three modes.
N10/SMPTE
BETA 7.5
BETA 0
@¡NTSC SETUP LEVEL menu
Select the NTSC setup level from two modes.
[AUTO]
The 7.5 setup level is mainly used in north America.
The 0 setup level is mainly used in Europe.
@™ACC menu
Set ACC (Auto Color Control) circuit on or off. When
[OFF]
the fine adjustment is necessary, select OFF on the
ACC menu.
Normally select ON.
@£LANGUAGE menu
You can select the menu language from among five
languages (English, German, French, Italian, Spanish).
@¢DEGAUSS DELAY menu
Set the time for the degauss function to work after the
power is turned on.
This function can be set at 0 to 99 seconds.
BVM-20M4DE/20M4E only
@∞LANDING screen
If the color is not uniform even after you press the
DEGAUSS button, you can adjust the landing so as to
obtain color uniformity on this screen.
The following two methods are available to adjust the
[OFF]
landing.
When the signals of the horizontal lines are
input and displayed:
Press the ./– or >/+ button until the lines are
displayed on the screen as horizontally as possible.
When the signals of the white color are input
and displayed:
Press the ./– or >/+ button until the white color on
the screen become as uniform as possible.
To reset the setting to standard (00), press the
./– or >/+ buttons at the same time.
for 100/0/100/0 signal
for 100/7.5/75/7.5 signal
for 100/0/75/0 signal
[N10/SMPTE]
[0]
[ON]
[ENGLISH]
[0]
11(E)