Table of Contents
Advertisement
Molex Connector Specifications
The following table provides electrical, mechanical, and environmental performance
specifications for the Molex connector.
Item
Electrical Performance
Contact Resistance
Insulation Resistance
Dielectric Strength
Mechanical Performance
FPC Insertion/
Withdrawal Force
FPC Retention Force
Terminal Retention
Force
Environmental Performance (and Other)
Repeated Insertion /
Withdrawal
Temperature Rise
Table 4-2. Molex Connector Specifications
Test Condition
Mate applicable FPC, measure by dry
circuit, 20 mV max., 10 mA.
(JIS C5402 5.4)
Mate applicable FPC, apply 500V DC
between adjacent terminal or ground.
(JIS C5402 5.2/MIL-STD-202 Method
302)
Mate applicable FPC, apply 250V AC
(rms) for 1 minute between adjacent
terminal or ground.
(JIS C5402 5.1/MIL-STD-202 Method
301)
Insert and withdraw FPC at the rate of
25 ±3 mm / minute.
Insert the actuator, pull the FPC at the
rate of 25 ±3 mm / minute.
Apply axial pull out force at the rate of
25 ±3 mm / minute on the terminal
assembled in the housing.
Insert and withdraw actuator up to 20
cycles, at the rate of less than 10 cycles/
minute.
Carrying rated current load (UL 498).
Electrical Interface
Requirement
Odd CKT: 80 milliohms max.
Even CKT: 40 milliohms max.
50 Megohms min.
No breakdown
See
Table 4-3 on page
See
Connector Retention
Force (min.)
on page 4-10.
0.8 N (0.08 kgf) min.
Contact
Odd CKT: 100
Resistance
milliohms max.
Even CKT: 60
milliohms max.
o
Temperature
30
max.
rise
4-10.
4-7
Advertisement
Table of Contents
