Communication Connectors And Terminals - Mitsubishi Electric F800-E Series Instruction Manual

2.7

Communication connectors and terminals

2.7.1
PU connector
Removal and reinstallation of the accessory cover
• Loosen the two screws on the accessory cover.
(These screws cannot be removed.)
To install the accessory cover, fit it securely and tighten the screws. (Tightening torque: 0.40 to 0.45 N·m)
Mounting the operation panel (FR-LU08) or parameter unit (FR-PU07) on
the enclosure surface
• The operation panel can be used for setting the inverter parameters, monitoring various items, and checking fault
indications.
• Having an operation panel (FR-LU08) or a parameter unit (FR-PU07) on the enclosure surface is convenient. With a
connection cable, the operation panel (FR-LU08) or the parameter unit (FR-PU07) can be mounted to the enclosure
surface and connected to the inverter.
Use the option FR-CB2[ ], or connectors and cables available on the market.
(To install the operation panel (FR-LU08), the optional connector (FR-ADP) is required.) )
Securely insert one end of the connection cable until the stoppers are fixed.
Parameter unit (FR-PU07)
(option)
NOTE
• Refer to the following table when fabricating the cable on the user side. Keep the total cable length within 20 m.
• Commercially available products (as of February 2015)
Name
SGLPEV-T (Cat5e/300 m) 24AWG  4P
Communication cable
RJ-45 connector 5-554720-3
• For the details of the FR-LU08, refer to the FR-LU08 Instruction Manual.
Parameter unit connection cable
(FR-CB2[ ]) (option)
Operation panel (FR-LU08)
(option)
Operation panel connection
connector (FR-ADP)
(option)
Model
Communication connectors and terminals
• Push the upper part of the accessory cover and pull the
accessory cover to remove.
Manufacturer
Mitsubishi Cable Industries, Ltd.
Tyco Electronics
INSTALLATION AND WIRING
2
43