Step 3: Connecting The Video Cords - Sony DVP-NS333 Operating Instructions Manual

Step 3: Connecting the Video Cords

Connect this player to your TV monitor, projector, or AV amplifier (receiver) using a video cord.
Select one of the patterns A through B, according to the input jack on your TV monitor,
projector, or AV amplifier (receiver).
A
INPUT
VIDEO
L
AUDIO
R
TV, projector, or AV
amplifier (receiver)
to LINE OUT (VIDEO)
l : Signal flow
If you are connecting to a video input jack
A
Connect the yellow plug of the audio/video cord (supplied) to the yellow (video) jacks. You will
enjoy standard quality images.
Use the red and white plugs to connect to the audio input jacks (page 19). (Do this if you are
connecting to a TV only.)
B If you are connecting to a SCART (EURO AV) input jack
Connect the SCART (EURO AV) cord (not supplied). Be sure to make the connections firmly to
avoid hum and noise. When you connect using the SCART (EURO AV) cord, check that the TV
conforms to S video or RGB signals. Refer to the operating instructions supplied with the TV to
be connected. Also, when you set "LINE" to "S VIDEO" or "RGB" under "SCREEN SETUP"
in the Setup Display (page 62), use a SCART (EURO AV) cord that conforms to each signal.
16
(yellow)
Audio/video cord
(supplied)
(yellow)
DIGITAL OUT LINE OUT
PCM/DTS/MPEG/
DOLBY DIGITAL
R-AUDIO-L
COAXIAL OPTICAL
Yellow (Video)
White (L)
Red (R)
SCART (EURO AV)
cord (not supplied)
VIDEO
CD/DVD Player
to SCART (EURO AV) Input
TV
to t LINE (RGB) - TV
LINE
(RGB)
-TV
Yellow (Video)
White (L)
Red (R)
B