Settings For The Sound (Audio Setup) - Sony DVP-LS500 Operating Instructions Manual

Settings for the Sound
(AUDIO SETUP)
"AUDIO SETUP" allows you to set the sound
according to the playback and connection
conditions.
Select "AUDIO SETUP" in the Setup
Display. To use the display, see "Using the
Setup Display" (page 62).
The default settings are underlined.
AUDIO SETUP
AUDIO ATT (attenuation)
If the playback sound is distorted, set this
item to "ON." The player reduces the audio
output level.
This function affects the output of the
following jacks:
– LINE OUT L/R (AUDIO) jacks
– LINE (RGB)-TV jack
OFF
Normally, select this position.
ON
Select this when the playback sound
from the speakers is distorted.
AUDIO DRC (Dynamic Range Control)
(DVD VIDEO/DVD-RW only)
Makes the sound clear when the volume is
turned down when playing a DVD that
conforms to "AUDIO DRC." This affects the
output from the following jacks:
– LINE OUT L/R (AUDIO) jacks
– LINE (RGB)-TV jack
– DIGITAL OUT (OPTICAL or COAXIAL)
jack only when "DOLBY DIGITAL" is set
to "D-PCM" (page 67).
STANDARD Normally select this position.
TV MODE
WIDE
RANGE
66
AUDIO ATT:
AUDIO DRC:
DOWNMIX: DOLBY SURROUND
DIGITAL OUT:
DOLBY DIGITAL:
MPEG:
DTS:
Makes the low sounds clear
even if you turn the volume
down.
Gives you the feeling of being
at a live performance.
DOWNMIX (DVD VIDEO/DVD-RW only)
Switches the method for mixing down to 2
channels when you play a DVD which has
rear sound elements (channels) or is recorded
in Dolby Digital format. For details on the
rear signal components, see "Displaying the
audio information of the disc" (page 49). This
function affects the output of the following
jacks:
– LINE OUT L/R (AUDIO) jacks
– LINE (RGB)-TV jack
– DIGITAL OUT (OPTICAL or COAXIAL)
jack when "DOLBY DIGITAL" is set to
"D-PCM" (page 67).
DOLBY
OFF
STANDARD
SUR-
ROUND
ON
D-PCM
PCM
OFF
NORMAL
DIGITAL OUT
Selects if audio signals are output via the
DIGITAL OUT (OPTICAL or COAXIAL)
jack.
ON
OFF
Setting the digital output signal
Switches the method of outputting audio
signals when you connect a component such
as an amplifier (receiver) or MD deck with a
digital input jack.
For connection details, see page 19.
Select "DOLBY DIGITAL," "MPEG," and
"DTS" after setting "DIGITAL OUT" to
"ON."
Normally, select this position.
Multi-channel audio signals are
output to two channels for
enjoying surround sounds.
Multi-channel audio signals are
downmixed to two channels for
use with your stereo.
Normally select this position. When
you select "ON," see "Setting the
digital output signal" for further
settings.
The influence of the digital circuit
upon the analog circuit is minimal.
AUDIO SETUP
AUDIO ATT:
AUDIO DRC:
DOWNMIX: DOLBY SURROUND
DIGITAL OUT:
DOLBY DIGITAL:
MPEG:
DTS:
OFF
STANDARD
ON
D-PCM
PCM
OFF