Programing The Cd Tracks; Program Play; Using The Cd Display - Sony CMT-E301 Operating Instructions Manual

Programing the CD tracks

— Program Play

You can make a program of up to 28 tracks in
the order you want them to be played.
1
Press CD (CD/REMAIN on the remote),
then place a CD.
2
Press ENTER/PGM (TUNER MEM/
ENTER/PGM on the remote) repeatedly
until "00 PR.01" appears in the display.
3
Press . m or M > until the
desired track appears in the display.
Programed step number
Selected track number
(including selected track)
4
Press ENTER/PGM (TUNER MEM/
ENTER/PGM on the remote).
The track is programed. The next program
step number appears, and "PROGRAM"
flashes.
5
To program additional tracks, repeat
steps 3 to 4.
6
Press u.
Program Play starts.
To Do this
Check the total Press ENTER/PGM (TUNER
number of MEM/ENTER/PGM on the remote)
programed repeatedly in stop mode. Each time
tracks you press the button, the selected
track number and the programed
step number appear in the display
in turn.
Press x twice until "PROGRAM"
Cancel Program
Play disappears from the display. The
program you made will be erased.
Tip
The program you made remains after Program Play
finishes. When Program Play remains in the system's
memory, "PROGRAM" flashes. To play the same
program again, press CD (CD/REMAIN on the
remote) and ENTER/PGM (TUNER MEM/ENTER/
PGM on the remote), then press u.

Using the CD display

Press REMAIN (CD/REMAIN on the
remote) repeatedly.
The display changes as follows:
During normal play
Elapsed playing time on the current track t
Remaining time on the current track t
Remaining time on the current CD t
Elapsed playing time on the current track t ...
9