Sony CDX-L450X Operating Instructions (English, Español) Installation/Connections

FM/AM
Compact Disc
Player
Installation/Connections
CDX-L450X
Sony Corporation © 2001 Printed in Korea
1
1 2
4 5
2
7 8
2
2
A
B
AUDIO OUT
3-227-644-21 (1)
3
1
from car aerial *
* 1 Note for the aerial connecting
If your car aerial is an ISO (International Organisation for
Standardisation) type, use the supplied adaptor 6 to
connect it.
First connect the car aerial to the supplied adaptor, then
connect it to the aerial jack of the master unit.
2 RCA pin cord (not supplied)
*
* 1 Примечание о подсоединении антенны
6
* 2 Шнур с контактными штырьками RCA (не прилагается)
Cautions
3
•This unit is designed for negative earth 12 V
DC operation only.
•Do not get the wires under a screw, or caught
in moving parts (e.g. seat railing).
•Before making connections, turn the car
6
ignition off to avoid short circuits.
•Connect the power connecting cord 8 to the
unit and speakers before connecting it to the
auxiliary power connector.
•Run all earth wires to a common earth
point.
•Be sure to insulate any loose unconnected
wires with electrical tape for safety.
Notes on the power supply cord (yellow)
•When connecting this unit in combination with
other stereo components, the connected car
circuit's rating must be higher than the sum of
each component's fuse.
•When no car circuits are rated high enough,
connect the unit directly to the battery.
Parts Iist (1)
The numbers in the list are keyed to those in the
instructions.
Caution
Handle the bracket 1 carefully to avoid injuring
your fingers.
1
Connection example (2)
Notes (2-B)
• Be sure to connect the earth cord before
connecting the amplifier.
• If you connect an optional power amplifier and do
not use the built-in amplifier, the beep sound will
be deactivated.
* 2
L
6
R
AUDIO OUT
REAR
*
Fuse (10 A)
AUDIO OUT
A
Blue/white striped
AMP REM
Max. supply current 0.3 A
See "Power connection diagram"
on the reverse side for details.
Connection diagram (3)
A
To AMP REMOTE IN of an optional power
amplifier
This connection is only for amplifiers. Connecting
any other system may damage the unit.
Warning
If you have a power aerial without a relay box,
connecting this unit with the supplied power
connecting cord 8 may damage the aerial.
Notes on the control leads
• The power aerial control lead (blue) supplies +12 V
DC when you turn on the tuner.
• When your car has built-in FM/AM aerial in the
rear/side glass, connect the power aerial control
lead (blue) or the accessory power input lead (red)
to the power terminal of the existing aerial
booster. For details, consult your dealer.
• A power aerial without a relay box cannot be used
with this unit.
Memory hold connection
When the yellow power input lead is connected,
power will always be supplied to the memory circuit
even when the ignition switch is turned off.
Notes on speaker connection
• Before connecting the speakers, turn the unit off.
• Use speakers with an impedance of 4 to 8 ohms,
and with adequate power handling capacities to
avoid its damage.
• Do not connect the speaker terminals to the car
chassis, or connect the terminals of the right
speakers with those of the left speaker.
• Do not connect the earth lead of this unit to the
negative (–) terminal of the speaker.
• Do not attempt to connect the speakers in parallel.
• Connect only passive speakers. Connecting active
speakers (with built-in amplifiers) to the speaker
terminals may damage the unit.
Equipment used in illustrations (not supplied)
8
from the car's speaker connector
1 3 5 7
2 4 6 8
from the car's power connector
5 7
4 8
8
1
1
1
2
Примечания 2
Front speaker
Rear speaker
Power amplifier
Speaker, Rear, Right
+
1
Purple
Speaker, Rear, Right
–
2
Speaker, Front, Right
3 +
Speaker, Front, Right
4 –
Speaker, Front, Left
5 +
Speaker, Front, Left
–
6
Speaker, Rear, Left
+
7
Speaker, Rear, Left
8 –
Negative polarity positions 2, 4, 6, and 8 have striped
cords.
Yellow continuous power supply
4
Blue power aerial control
5
Red switched power supply
7
Black earth
8
Positions 1, 2, 3 and 6 do not have pins.
3
A
8
О проводах управления
Подсоединение для поддержки памяти
О подсоединении громкоговорителей