Wireless Interface Module (Wim) - Bosch Greensource SM024 Installation, Operation And Maintenance Manual

44 | Wireless Interface Module (WIM)

WIRELESS INTERFACE MODULE (WIM)
SM Series Water Source Heat Pumps are equipped
with an externally-mounted WIM that will provide a
Wi-Fi connection between the appliance and the
Bosch EasyStart app. (Refer to page #28.) The
WIM's mounting location can be seen in Fig. 69 and
Fig. 70:
Fig. 69 Vertical (VT) Unit WIM Mounting Location
On VT units, the WIM is mounted on the blower
access panel.
Fig. 70 Horizontal (HZ) Unit WIM Mounting Location
On HZ units, the WIM is mounted on the electrical
box access panel.
8733819578 (2019/02)
On the WIM is a label that displays the SSID,
Password, and a QR code on a button as well as a
LED indicator that will glow RED when the WIM is
active. This is shown in Fig. 71.
Fig. 71 WIM
[1] SSID and Password
[2] QR Code
[3] LED indicator
The operation of the WIM is very simple—press the
button on the face (where the label is affixed) and
the WIM will broadcast the unique Wi-Fi network
signal so the Bosch EasyStart app can connect and
communicate with the WIM. The WIM's operation
is explained within the Bosch EasyStart app and in
its IOM.
Subject to change without prior notice
Greensource CDi Series SM
Greensource CDi Series SM Model