Sony CDP-XE220 Operating Instructions Manual page 5

You can adjust the output level to the amplifier
(CDP-XE520 and CDP-XE320 only)
Press LINE OUT LEVEL +/– on the remote. You can
reduce the output level up to –20 dB.
When you reduce the output level, "FADE" (or
the CDP-XE320) appears in the display.
When you turn off the player, the output level
automatically returns to the maximum level.
• If you have a digital component such as a digital
amplifier, D/A converter, DAT or MD
Connect the component via the DIGITAL OUT (OPTICAL)
connector using the optical cable (not supplied). Take off
the cap and plug in the optical cable.
Note that you cannot use the following functions when
making this connection:
• Fading In or Out (see page 15)
• Time Fade (see page 16)
• Adjusting the output level using the LINE OUT
LEVEL +/– buttons on the remote (see above)
POC-15
Optical cable (not supplied)
CD player
DIGITAL
OUT
OPTICAL
Note
When you connect via the DIGITAL OUT (OPTICAL)
connector, noise may occur when you play CD software other
than music, such as a CD-ROM.
If you have a Sony component with the CONTROL A1
jack (CDP-XE520 only)
Connect the component via the CONTROL A1 jack. You
can simplify the operation of audio systems composed of
separate Sony components. For details, refer to the
supplementary "S-Link TM /CONTROL-A1 Control
System" instructions.
Connecting the mains lead
Connect the mains lead to a wall outlet.
for
FADE
Where do I go next?
Now you're ready to use your player.
If you aren't familiar with how to play CDs, go to the section
"Playing a CD" on page 6.
Then, go to the following sections for other operations.
Digital component
DIGITAL
INPUT
OPTICAL
Getting Started
Getting Started
GB
5