Fading In Or Out - Sony CDP-XE220 Operating Instructions Manual

1
Press EDIT/TIME FADE before you start playing
until "EDIT" appears and "TAPE A" flashes in the
display.
2
Press 0 or ) to specify the tape length.
Each time you press these buttons, the display
changes as shown below with the tape length of
one side .
n HALF ˜ C-46 23.00 ˜ C-54 27.00 ˜ C-60 30.00 N
n - -. - - ˜ C-90 45.00 ˜ C-74 37.00 N
When you select "HALF"
The player divides the total playing time of the disc in
half, keeping the original order.
Note that you cannot select "HALF" when the disc has
more than 24 tracks.
3
Press EDIT/TIME FADE to have the player create
the programme.
The display shows the tracks to be recorded.
"TAPE B" flashes in the display.
4
When you record on both sides of the tape, press
EDIT/TIME FADE again.
The player inserts a pause, then creates the
programme for side B. The display shows the
programmed tracks.
When you record on one side of the tape or on a
DAT or MD, skip this step.
5
Start recording on the deck and then press · on
the player.
When you record on both sides of the tape, the
player pauses at the end of the programme for side
A.
6
When you record on side B, reverse the tape and
press · or P on the player to resume playing.
To cancel Time Edit
Press PLAY MODE.
When using the remote, press CONTINUE.
You can specify the tape length freely
You can set the tape length using ≠ AMS ±.
Example: When the tape length of one side is 30 minutes
and 15 seconds
1 To set the minutes, turn ≠ AMS ± until
"30" appears in the display, then push
≠ AMS ±.
2 To set the seconds, turn ≠ AMS ± until
"15" appears in the display, then push
≠ AMS ±.
Recording From CDs Recording From CDs
When tracks, which aren't numerically consecutive on
the disc, are programmed consecutively (i.e. 1, 3, 5
etc.)
A one-second access time blank is added between the
tracks.
To check and change your programme
See page 13.

Fading In or Out

You can manually fade in or out to prevent tracks from
starting or ending abruptly.
Note that you cannot use this effect when you use the
DIGITAL OUT (OPTICAL) connector.
Fading in or out at the point you want
(CDP-XE520 and CDP-XE320 only)
• CDP-XE520
• CDP-XE320
Number buttons
FADER
FADER
(Continued)
15
GB