Displaying Stored Results - AEG BMG 5677 Instruction Manual

c. After examining itself, LCD will show "0" mmHg that indicate
you can begin to measure.
d. Press the „ " button to begin automatic inflation.
e. Then the monitor inflates the cuff until sufficient pressure has
built up for a measurement. Then the monitor slowly releases
air from the cuff and carries out the measurement. Finally the
blood pressure and pulse rate will be calculated and displayed
on the LCD screen. The blood pressure classification indicator
and Irregular heartbeat symbol (if any) will blink on the screen.
The result will be automatically stored in the monitor.
f. After measurement, the monitor will turn off automatically after
1 minute of no operation. Alternatively, you can press the "O/I" button to turn off
the monitor manually.
g. Pressing "M" button after measuring, you can reading memory.
h. Pressing „1-3" button, you can read the average value of the last three measure-
ments.
i. If you want to measure again, just press the„ " button.
Note:
Please consult a health care professional for interpretation of pressure measurements.

8. DISPLAYING STORED RESULTS

a. Switch the monitor on by using the "ON/OFF" switch (ON position).
b. After power on or measurement, press button "M" and enter the mode of reading
results. The last result will be displayed with date and time. Irregular heartbeat sym-
bol (if any) and the indicator of blood pressure classification will blink at the same
time. Press "M" button repeatedly to review the results measured previously.
English
101