Sony 480p Operating Instructions Manual page 91

Sony operating instructions cd/dvd player dvp-cx985v
Table of Contents

Advertisement

AUDIO FILTER (except Super Audio CD)
Selects a digital filter to reduce noise above
22.05 kHz (Sampling frequency (Fs) of the
audio source is 44.1 kHz), 24 kHz (Fs is 48
kHz), or 48 kHz (Fs is above 96 kHz).
SHARP
Provides a wide frequency
range and spatial feeling.
SLOW
Provides smooth and warm
sound.
Note
There may be little effect by changing the digital
filter depending on the disc or playback
environment.
DOWNMIX (DVD VIDEO/DVD-RW only)
Switches the method for mixing down to 2
channels when you play a DVD which has
rear sound elements (channels) or is recorded
in Dolby Digital format. For details on the
rear signal components, see "Displaying the
disc's audio information" (page 68). This
function affects the output of the following
jacks:
– LINE OUT AUDIO L/R 1/2 jacks
– DIGITAL OUT (COAXIAL or OPTICAL)
jack when "DOLBY DIGITAL" is set to
"D-PCM" (page 91).
DOLBY
Normally select this position.
SUR-
Multi-channel audio signals are
ROUND
output to two channels for
enjoying surround sounds.
NORMAL
Multi-channel audio signals are
downmixed to two channels for
use with your stereo.
DIGITAL OUT (except Super Audio CD)
Selects if audio signals are output via the
DIGITAL OUT (COAXIAL or OPTICAL)
jack.
ON
Normally select this position. When
you select "ON," see "To set the digital
output signal" for further settings.
OFF
The influence of the digital circuit
upon the analog circuit is minimal.
Note
Super Audio CD audio signals are not output from
the digital jack.
To set the digital output signal
The following switches the method of
outputting audio signals when you connect a
component such as an amplifier (receiver) or
MD deck with a digital input jack.
For connection details, see page 21.
Select "DOLBY DIGITAL," "DTS," and
"48kHz/96kHz PCM" after setting
"DIGITAL OUT" to "ON."
AUDIO SETUP
AUDIO ATT:
AUDIO DRC:
AUDIO FILTER:
DOWNMIX:
DIGITAL OUT:
DOLBY DIGITAL:
DTS:
48kHz/96kHz PCM:
If you connect a component that does not
conform to the selected audio signal, a loud
noise (or no sound) will come out from the
speakers, damaging your ears or speakers.
• DOLBY DIGITAL (DVD VIDEO/DVD-
RW only)
Selects the type of Dolby Digital signal.
D-PCM
Select this when the player is
connected to an audio
component lacking a built-in
Dolby Digital decoder. You can
select whether the signals
conform to Dolby Surround
(Pro Logic) or not by making
adjustments to the
"DOWNMIX" item in
"AUDIO SETUP" (page 91).
DOLBY
Select this when the player is
DIGITAL
connected to an audio
component with a built-in
Dolby Digital decoder.
• DTS (DVD VIDEO only)
Selects the type of DTS signal.
D-PCM
Select this when the player is
connected to an audio
component without a built-in
DTS decoder.
DTS
Select this when the player is
connected to an audio
component with a built-in DTS
decoder.
OFF
STANDARD
SHARP
DOLBY SURROUND
ON
D-PCM
D-PCM
48kHz/16bit
91

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dvp-cx985vHt-9900m

Table of Contents