Browser Menu Parameter Function Groups - Siemens SITRANS LUT400 Manual

Browser Menu Parameter Function Groups

Notes:
• Below is a list of parameter function groups (not individual parameters) available on the
browser. A parameter number is referenced for more information on the parameters within
each function group.
• An asterisk (*) in the left column means this parameter or function group will not display
on the browser menu unless the SITRANS LUT400 is configured for Pump and Flow* or
OCM* at startup, and the device connected supports this functionality.
Parameter Function Group
*
I
DENTIFICATION
Device
S
ETUP
Sensor
Calibration
Rate
Fail-Safe
Current Output
Volume
Pumps
*
*
*
*
Alarms
*
*
Page 46 COMMUNICATIONS FOR SITRANS LUT400 (HART) – MANUAL
Current Output Function
Current Output Setup
Level and Volume Breakpoints
Basic Setup
Modifiers
Wall Cling Reduction
Energy Savings
Pump Run-On
Pump Start Delays
Totalizers
High Level Alarm
Low Level Alarm
Switch (DI) Alarm
In-bounds Level Alarm
Out-of-bounds Level Alarm
Low Temperature Alarm
High Temperature Alarm
Fail-safe Fault Alarm
High Flowrate Alarm
Low Flowrate Alarm
Relay Logic
Time to Spill
Parameter
Number
3. 1
2
2. 1
2.2
2.3
2.4
2.5
2.6
2.7
2.8
A5E33701270