Technical Features; Power Saving Function; Reducing The Power Consumption; Automatic Picture Quality Adjustment Function - Sony SDM-HS53 Operating Instructions Manual

Technical Features

Power saving function

This monitor meets the power-saving guidelines set by VESA,
E S
NERGY TAR, and NUTEK. If the monitor is connected to a
computer or video graphics board that is DPMS (Display Power
Management Signaling) compliant, the monitor will automatically
reduce power consumption as shown below.
SDM-HS53
Power mode Power consumption
normal 25 W (max.)
operation
active off* 1 W (max.)
(deep sleep)**
power off 1 W (max.)
SDM-HS73
Power mode Power consumption
normal 45 W (max.)
operation
active off* 1 W (max.)
(deep sleep)**
power off 1 W (max.)
SDM-HS93
Power mode Power consumption
normal 50 W (max.)
operation
active off* 1 W (max.)
(deep sleep)**
power off 1 W (max.)
* When your computer enters the "active off" mode, the input signal is
cut and NO INPUT SIGNAL appears on the screen. After 5 seconds,
the monitor enters the power saving mode.
** "deep sleep" is the power saving mode defined by the Environmental
Protection Agency.

Reducing the power consumption

(
If you set the
the front of the monitor, the backlight level is reduced and the
power consumption is reduced, too.
Press the
(power)
1
indicator
green
LOW appears on the screen and the backlight level is reduced.
LOW automatically disappears after about 5 seconds.
orange
Automatic picture quality
off
adjustment function
When the monitor receives an input signal, it automatically
matches the signal to one of the factory preset modes stored in the
(power)
1
monitor's memory to provide a high quality picture at the center
indicator
of the screen.
green
For input signals that do not match one of the factory preset
modes, the automatic picture quality adjustment function of this
orange
monitor automatically adjusts the picture position, phase, and
pitch, and ensures that a clear picture appears on the screen for
any timing within the monitor's frequency range (horizontal: 28 –
off
61 kHz (SDM-HS53), 28 – 80 kHz (SDM-HS73/HS93), vertical:
48 – 75 Hz).
Consequently, the first time the monitor receives input signals
that do not match one of the factory preset modes, the monitor
(power)
1
may take a longer time than normal for displaying the picture on
indicator
the screen. This adjustment data is automatically stored in
green
memory so that next time, the monitor will function in the same
way as when the monitor receives the signals that match one of
the factory preset modes.
orange
In all modes as above, if the picture is adjusted, the adjustment
data is stored as a user mode and automatically recalled whenever
off
the same input signal is received.
Note
While the automatic picture quality adjustment function is activated, only
the 1 (power) switch will operate.

mode)

mode to LOW by pressing the
button several times until LOW appears.
,
:
button on
L OW
GB
15