Siemens Sinamics G120 Function Manual page 347

Safety integrated
Hide thumbs Also See for Sinamics G120:
Table of Contents

Advertisement

Procedure
To replace the inverter, proceed as follows:
1. Disconnect the line voltage to the inverter and (if installed) the external 24 V supply or the
voltage for the digital outputs of the inverter.
2. Remove the connecting cables of the inverter.
3. Remove the defective inverter.
4. Install the new inverter.
5. Connect all of the cables to the inverter.
6. Reconnect the line voltage, and (if being used) the external 24 V supply or the voltage for
the digital outputs of the inverter.
7. In Startdrive, open the project that matches the drive.
8. Select "Load to device".
9. Connect Startdrive online with the drive.
The inverter signals faults after the download. Ignore these faults, as they will be
automatically acknowledged by the following steps.
10.Press the "Start safety commissioning" button.
11.Enter the password for the safety functions.
12.Confirm the prompt for saving your settings (copy RAM to ROM).
13.Disconnect the online connection.
14.Switch off the inverter supply voltage.
15.Wait until all LEDs on the inverter go dark.
16.Switch on the inverter supply voltage again.
17.Perform a reduced acceptance test.
(Page 366)
You have replaced the inverter and transferred the safety function settings from the PC to the
new inverter.
Replacing the inverter with data backup in the Operator Panel (BOP-2 or IOP)
Procedure
To replace the inverter, proceed as follows:
1. Disconnect the line voltage to the inverter and (if installed) the external 24 V supply or the
voltage for the digital outputs of the inverter.
2. Remove the connecting cables of the inverter.
3. Remove the defective inverter.
4. Install the new inverter.
5. Connect all of the cables to the inverter.
Safety Integrated - SINAMICS G110M, G120, G120C, G120D and SIMATIC ET 200pro FC-2
Function Manual, 01/2017, FW V4.7 SP6, A5E34261271B AD
Reduced acceptance after a component has been replaced and a firmware change
7.4 Replacing the SINAMICS G120C converter
Corrective maintenance
347

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents