Table of Contents
Advertisement
INSTALLATION ON A ROOF MOUNTING FRAME
ASSEMBLY
The frame is supplied as a single package and shipped folded down for ease of transport and handling. It is easy field
assembled as all parts required are supplied with the frame.
SECURING THE FRAME
To ensure proper mating with units (figure 7), it is mandatory that the roof mounting frame be squared to roof structure as
follows:
-With frame positioned levelled in the desired location on roof trusses, tack weld corner of frame.
-Measure frame diagonally from corner to corner as shown
in figure 7. These Dimensions must be equal in order for
the fame to be square.
-It is extremely important to sight frame from all corner to
ensure it is not twisted across. Shim frame under any low
side. The maximum slope tolerance is 5mm per linear
meter in any direction.
-After the frame has been squared, straightened and
shimmed, weld or secure the frame to the roof deck.
Fig. 7
NOTE : It must be securely fastened to the roof as per
local codes and regulations.
Page 40 - IOM / ROOFTOP BALTIC Series - 0704 - E
Hide quick links:
Advertisement
Table of Contents
