Table of Contents
Advertisement
Installation
Installing the Outdoor Unit (Boiler)
Position the outdoor unit so that the air flows into an open area, where there are no plants and animals. If the unit is to be installed within
a mile of the sea you need to have the unit coated suing Blygold, ask us for details. If you are applying for RHI and going through MCS you
need to make sure the system meets MIS020.
Install the outdoor unit on a flat, stable surface, it needs to be securely mounted at least 100mm off the ground on rubber feet. The unit
must be bolted down for security using 10mm bolts and Zebedee's.
The unit must have adequate drainage away from the unit; it can produce up to 6 L / hour of condensate. If you are installing the unit at
height you can install a drain pan under the unit but its best to let the unit drain into the ground.
Dimensions:
Size 16 - 1420mm (h) 940mm (w) 330mm (d) 103kg
Size 9
- 998mm (h) 940mm (w) 330mm (d) 75kg
Size 5
- 798mm (h) 880mm (w) 310mm (d) 59kg
The space around the unit is very important, allow:
300mm to the left hand side (facing the front of the unit),
600mm to the right of the unit,
300mm to the rear of the unit and 1500mm to the front of the
unit.
Installing the Control Box MIM-03AN
The control box contains the flow switch, cylinder sensor (blue) 2
red safety sensors, some cables for a backup heater, a black cable
for smart grid connections and the remote controller.
Install the control unit indoors, it's not waterproof.
It needs to be sited within 15m of the hot water cylinder, less than
100m from the outdoor unit and as near as possible to the pump,
flow switch and any zone valves.
The box is 323mm wide, 339mm high, 131mm deep.
The Samsung remote controller MUST be in a heated space above
5 degrees C.
Installation Manual.indd 13
600 or more
300 or more
13
31/08/2018 19:01:19
Hide quick links:
Advertisement
Table of Contents
