Hitachi H8/300H Series Programming Manual page 3

Page Item
P175 2.2.58 (2) STC (W)
2.2.58 (2) STC (W)
P176 2.2.58 (2) STC (W)
P180 2.2.60 SUBS
P189 (1) Data Transfer Instructions MOV.W @ERs+,Rd
(1) Data Transfer Instructions MOV.W Rs,@ERd
(1) Data Transfer Instructions MOV.W Rs,@(d:24,ERd)
(1) Data Transfer Instructions MOV.L #xx:32,ERd
P190 (1) Data Transfer Instructions MOV.L @ERs+,ERd
(1) Data Transfer Instructions POP.L ERn
(1) Data Transfer Instructions PUSH.L ERn
P191 (2) Arithmetic Operation Instructions DAA Rd
P192 (2) Arithmetic Operation Instructions CMP.L #xx:32,ERd
P196 (5) Bit Manipulation Instructions
P197, (6) Branch Instructions
P198
P198 (7) System Control Instructions LDC @ERs,CCR
(7) System Control Instructions LDC @(d:16,ERs),CCR
(7) System Control Instructions LDC @(d:24,ERs),CCR
(7) System Control Instructions LDC @ERs+,CCR
P204 Table 2-3 Instruction Codes (4) MOV.B@aa:16,Rd
P231 Table 2-8 Bus States BSR d:16
P234, Table 2-8 Bus States POP.W Rn to PUSH.L ERn
P235
P240 Figure 3-2 State Transitions
Assembler Format
Operand Format and Number of
States Required for Execution
Operation
Description
Instruction amended
Assembler format amended
Mnemonic amended
Operation amended
Operation amended
Operation amended
Number of execution states
amended
Operation and number of
execution states amended
Operation amended
Number of execution states
amended
Number of execution states
amended
Condition code amended
Number of execution states
amended
Table amended
Added
Operation amended
Operation amended
Operation amended
Operation amended
Instruction format amended
Execution order nos.2 to
5 amended
Instruction added
Figure amended