Sony CDX-GT500EE Installation/Connections

2-663-188-41 (1)
FM/AM
Compact Disc Player
Installation/Connections
Установка/Подсоединение
CDX-GT500EE
© 2006 Sony Corporation
Printed in Thailand
  

 
× 2
 
× 4
Front speaker
Power amplifi er
Rear speaker
CD/MD changer
Active subwoofer Rotary commander RM-X4
A
AUDIO OUT
FRONT
SUB OUT ( MONO )
AUDIO OUT
REAR
B
BUS AUDIO IN
BUS CONTROL IN
BUS AUDIO IN
Source selector*
*
XA-C30
BUS CONTROL IN
* not supplied
Cautions Connection example
• This unit is designed for negative earth 12 V DC
Notes (-A)
operation only. • Be sure to connect the earth lead before connecting the
amplifi er.
• Do not get the leads under a screw, or caught in moving
• The alarm will only sound if the built-in amplifi er is used.
parts (e.g. seat railing).
Tip (-B- )
• Before making connections, turn the car ignition off to
For connecting two or more CD/MD changers, the source
avoid short circuits.
selector XA-C30 (not supplied) is necessary.
• Connect the power connecting lead  to the unit and
speakers before connecting it to the auxiliary power
connector.
Connection diagram
• Run all earth leads to a common earth point.
• Be sure to in su late any loose un con nect ed leads with
electrical tape for safety.  To AMP REMOTE IN of an optional power
amplifi er
Notes on the power supply lead (yellow)
This connection is only for amplifi ers. Connecting any other
• When connecting this unit in combination with other
system may damage the unit.
stereo components, the connected car circuit's rating
 To the interface cable of a car telephone
must be higher than the sum of each component's fuse.
• When no car circuits are rated high enough, connect
the unit directly to the battery. Warning
If you have a power aerial without a relay box,
connecting this unit with the supplied power connecting
Parts Iist
lead  may damage the aerial.
Notes on the control and power supply leads
• The numbers in the list are keyed to those in the
• The power aerial control lead (blue) supplies +12 V DC when
instructions.
you turn on the tuner.
• The bracket  and the protection collar  are • When your car has built-in FM/AM aerial in the rear/side glass,
connect the power aerial control lead (blue) or the accessory
attached to the unit before shipping. Before mounting
power input lead (red) to the power terminal of the existing
the unit, use the release keys  to remove the bracket
aerial booster. For details, consult your dealer.
 and the protection collar  from the unit. For
• A power aerial without a relay box cannot be used with this
details, see "Removing the protection collar and the unit.
bracket ()" on the reverse side of the sheet.
Memory hold connection
• Keep the release keys  for future use as they
When the yellow power input lead is connected, power will
always be supplied to the memory circuit even when the ignition
are also necessary if you remove the unit from
switch is turned off.
your car.
Notes on speaker connection
Caution • Before connecting the speakers, turn the unit off.
Handle the bracket  carefully to avoid injuring your
• Use speakers with an impedance of 4 to 8 ohms, and with
adequate power handling capacities to avoid its damage.
fi ngers.
• Do not connect the speaker terminals to the car chassis, or
connect the terminals of the right speakers with those of the
left speaker.
• Do not connect the earth lead of this unit to the negative (–)
terminal of the speaker.
• Do not attempt to connect the speakers in parallel.
• Connect only passive speakers. Connecting active speakers
(with built-in amplifi ers) to the speaker terminals may damage
the unit.

• To avoid a malfunction, do not use the built-in speaker leads
installed in your car if the unit shares a common negative (–)
Catch
lead for the right and left speakers.
Note
• Do not connect the unit's speaker leads to each other.
Before installing, make sure that the catches on both sides of
Note on connection
the bracket  are bent inwards 2 mm. If the catches are straight
If speaker and amplifi er are not connected correctly, "Failure"
or bent outwards, the unit will not be installed securely and may
appears in the display. In this case, make sure the speaker and
spring out.
amplifi er are connected correctly.
* 2
BUS AUDIO IN
* 3
/AUX IN
AUDIO OUT
L
* 2
R
SUB OUT ( MONO )
BUS AUDIO AUDIO
AUDIO OUT OUT
* 1 from car aerial IN REAR FRONT
Fuse (10 A)
AUDIO OUT REAR


Blue/white striped
AMP REM
Max. supply current 0.3 A
Light blue
ATT
* 1 Note for the aerial connecting * 3
If your car aerial is an ISO (International
Organization for Standardization) type, use the
supplied adaptor  to connect it. First connect the
car aerial to the supplied adaptor, then connect it
to the aerial jack of the master unit. * 4
* 2 RCA pin cord (not supplied)
* 3 Be sure to match the colour-coded cord for audio
to the appropriate jacks from the unit. If you * 5
connect an optional CD/MD changer, you cannot
use AUX IN terminal. * 6
* 4 Auxiliary optional equipment such as portable DVD * 7
player (not supplied)
* 5 Supplied with the auxiliary equipment
* 6 Supplied with XA-C30
* 7 Insert with the cord upwards
See "Power connection diagram" on the reverse
* 1
side for details.

* 2
Пpимeчaниe

Примечания (-A)

Совет (-B- )



О проводах управления и питания









* 5
Source selector
(not supplied)
* 4
Supplied with the CD/MD changer
XA-C30
* 6
REMOTE
FRONT
IN
* 7
BUS
CONTROL IN
from the car's speaker
connector
Speaker, Rear, Right
1 + 5
Purple White
Speaker, Rear, Right
2 – 6
Speaker, Front, Right
3 + 7
Grey Green
Speaker, Front, Right
4 – 8
Negative polarity positions 2, 4, 6, and 8 have striped leads.
from the car's power connector
Yellow continuous power supply
4 7
Blue power aerial control
5 8
Orange/White switched illumination power supply
6
Positions 1, 2, 3, and 6 do not have pins.
Подсоединение для поддержки памяти
Примечания относительно подсоединения
громкоговорителей
Пpимeчaниe отноcитeльно подcоeдинeния
1 3 5 7
2 4 6 8
Speaker, Front, Left
+
Speaker, Front, Left
–
Speaker, Rear, Left
+
Speaker, Rear, Left
–
5 7
4 6 8
Red switched power supply
Black earth