Download Print this page
   

Advertisement

Getting Started
Resetting the unit
Before operating the unit for the first time or
after replacing the car battery, you must reset
the unit.
Press the reset button with a pointed object, such
as a ball-point pen.
Reset button
Notes
• Pressing the reset button will erase the clock
setting and some memorized program and
memory functions.
• When you connect the power supply cord to the
unit or reset the unit, wait for about 10 seconds
before you insert a disc. If you insert a disc within
these 10 seconds, the unit will not be reset, and
you will have to press the reset button again.
Additional Information
Before playing, clean the discs with an optional
Precautions
cleaning cloth. Wipe each disc from the center
out.
Do not use solvents such as benzine, thinner,
• If your car was parked in direct sunlight
commercially available cleaners, or antistatic
resulting in a considerable rise in temperature
spray intended for analog discs.
inside the car, allow the unit to cool off before
operating it.
• If no power is being supplied to the unit,
check the connections first. If everything is in
order, check the fuse.
• If no sound comes from the speakers of a two-
speaker system, set the fader control to the
center position.
•If your car is equipped with a power antenna,
it will extend automatically while the unit is
Notes on moisture condensation
operating.
On a rainy day or in a very damp area, moisture
•Connecting this unit may cause some car
may condense on the lenses inside the CD
battery wear when your car has no ACC
player. Should this occur, the unit will not
(accessory) position on the ignition key switch.
operate properly. In this case, remove the disc
and wait for about an hour until the moisture
If you have any questions or problems
evaporates.
concerning your unit that are not covered in this
manual, please consult your nearest Sony dealer.
When you play 8 cm (3 in.) CDs
Use the optional Sony compact disc single
Notes on handling CDs
adapter (CSA-8) to protect the CD player from
A dirty or defective disc may cause sound
damage.
dropouts while playing. To enjoy optimum
sound, handle the disc by its edge. To keep the
disc clean, do not touch the surface.
Maintenance
Fuse replacement
When replacing the fuse, be sure to use one
matching the amperage rating stated on the
Do not stick paper or tape on the labeled surface.
original fuse. If the fuse blows, check the power
connection and replace the fuse. If the fuse
blows again after replacement, there may be an
internal malfunction. In such a case, consult
your nearest Sony dealer.
Do not expose the discs to direct sunlight or heat
sources such as hot air-ducts, or leave them in a
car parked in direct sunlight where there can be
a considerable rise in temperature inside the car.
Warning
Never use a fuse with an amperage rating
exceeding the one supplied with the unit as this
could damage the unit.
Specifications
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC DISTORTION
13 watts per channel minimum continuous average power into
4 ohms, 4 channels driven from 20 Hz to 20 kHz with no more than
1 % total harmonic distortion.
Other specifications
CD player section
System
Compact disc digital audio
system
Signal-to-noise ratio
90 dB
Frequency response
10 – 20,000 Hz
Wow and flutter
Below measurable limit
Laser Diode Properties
Material
GaAs + GaAlAs
Wavelength
785 ~ 815 nm (Typ.800 nm)
Emission Duration
Continuous
Laser output power
Less than 0.5 mW*
* This output is the value measured at a distance of
0.7 mm from the objective lens surface on the
Optical Pick-up Block.
Tuner section
FM
Tuning range
87.5 – 107.9 MHz
Antenna terminal
External antenna connector
Intermediate frequency
10.7 MHz
Usable sensitivity
12 dBf
Selectivity
75 dB at 400 kHz
Signal-to-noise ratio
65 dB (stereo),
68 dB (mono)
Harmonic distortion at 1 kHz
0.7 % (stereo),
0.5 % (mono)
Separation
35 dB at 1 kHz
Frequency response
30 – 15,000 Hz
AM
Tuning range
530 – 1,710 kHz
Antenna terminal
External antenna connector
Intermediate frequency
10.7 MHz/450 kHz
Sensitivity
30 µV
Power amplifier section
Outputs
Speaker outputs
(sure seal connectors)
Speaker impedance
4 – 8 ohms
Maximum power output 35 W
4 (at 4 ohms)
Dismounting the unit
1
Insert the supplied tool between the unit
and the frame, and rotate 90° to release
the hidden mounting spring. Repeat on
the opposite side and remove the frame.
10 mm (
13
/
32
90°
Fuse (10 A)
General
Outputs
Line output
Power amplifier control
Power antenna relay control
Tone controls
Bass ±8 dB at 100 Hz
Treble ±8 dB at 10 kHz
Power requirements
12 V DC car battery
(negative ground)
Dimensions
Approx. 178 50 178 mm
1
1
(7
/
2 7
/
in.)
8
8
(w/h/d)
Mounting dimensions
Approx. 182
53 162 mm
1
1
1
(7
/
2
/
6
/
in.)
4
8
2
(w/h/d)
Mass
Approx. 1.2 kg (2 lb. 10 oz.)
Supplied accessories
Parts for installation and
connections (1 set)
Optional accessories
Cleaning cloth XP-CD1
Compact disc single adapter
CSA-8
Design and specifications are subject to change
without notice.
2
Insert a flathead screwdriver between the
bracket and mounting spring. Gently pry
the spring toward the unit while pulling
the unit out a little. Repeat on the
opposite side and remove the unit.
in.)
4 mm (
3
/
in.)
16
FM/AM
Compact Disc
Player
Operating Instructions
Owner's Record
The model and serial numbers are located on the bottom of the unit.
Record the serial number in the space provided below.
Refer to these numbers whenever you call upon your Sony dealer regarding this
product.
Model No. CDX-1150 Serial No.
For installation and connections, see the supplied installation/connections
manual.
CDX-1150
1999 by Sony Corporation
Printed in Japan
Warning
Welcome !
This equipment has been tested and found to
Thank you for purchasing the Sony Compact
comply with the limits for a Class B digital
Disc Player. This unit lets you enjoy a variety of
device, pursuant to Part 15 of the FCC Rules.
features.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment
generates, uses, and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the
equipment and receiver.
— Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
— Consult the dealer or an experienced radio/
TV technician for help.
You are cautioned that any changes or
modifications not expressly approved in this
manual could void your authority to operate
this equipment.
CAUTION
The use of optical instruments with this product
will increase eye hazard.
*I-3-866-373-11*
(1)

Advertisement

   Also See for Sony CDX-1150 Operating Instructions (primary manual)

   Related Manuals for Sony CDX-1150 Operating Instructions (primary manual)

   Summary of Contents for Sony CDX-1150 Operating Instructions (primary manual)

  • Page 1

    The model and serial numbers are located on the bottom of the unit. Record the serial number in the space provided below. Refer to these numbers whenever you call upon your Sony dealer regarding this product. Model No. CDX-1150 Serial No.

  • Page 2

    A CD is dirty or inserted upside Clean or insert the CD correctly. down. The CD player cannot be operated Press the reset button or 6. because of some problem. If the above-mentioned solutions do not help improve the situation, consult your nearest Sony dealer.

Comments to this Manuals

Symbols: 0
Latest comments: