Bluetooth (Handsfree Calling And Music Streaming); Bluetooth Operations; Pairing; About Bluetooth Icons - Sony Bluetooth BT3700U Operating Instructions Manual

Bluetooth (Handsfree calling
and Music streaming)

Bluetooth operations

To use the Bluetooth function, the following
procedure is necessary.

1 Pairing

When connecting Bluetooth devices for the
first time, mutual registration is required. This
is called "pairing." This registration (pairing)
is required only for the first time, as this unit
and the other devices will recognize each
other automatically from the next time. You
can pair up to 8 devices. (Depending on the
device, you may need to input a passcode for
each connection.)
2 Connection
To use the device after pairing is made, start
the connection. Sometimes pairing allows to
connect automatically.
3 Handsfree calling/Music streaming
You can talk handsfree and listen to music
when the connection is made.
Support site
http://support.sony-europe.com/
Pairing
First, register ("pair") a Bluetooth device
(cellular phone, etc.) and this unit with each
other. You can pair up to 8 devices. Once pairing
is established, there is no need for pairing again.
1
Place the Bluetooth device within 1 m
(3 ft) of this unit.
2
Press and hold (BT) until "
(about 5 seconds).
The unit enters pairing standby mode.
3
Set the Bluetooth device to search for
this unit.
18
A list of detected devices appears in the
display of the device to be connected. This
unit is displayed as "XPLOD" on the device
to be connected.
4
If Passcode* input is required on the
display of the device to be connected,
input "0000."
This unit and the Bluetooth device memorize
each other's information, and when pairing is
made, the unit is ready for connection to the
device.
"
complete.
5
Set the Bluetooth device to connect to
this unit.
"
made.
* Passcode may be called "passkey," "PIN code," "PIN
number" or "Password," etc., depending on the
device.
Note
" flashes
Pairing standby mode is not released until the
connection is made.

About Bluetooth icons

The following icons are used by this unit.
flashing
DR-BT30Q
XPLOD
XXXXXXX
XXXX
" flashes and then stays lit after pairing is
" or " " appears when the connection is
lit: Bluetooth signal on
flashing: Pairing standby mode
off: Bluetooth signal off
lit: Connection successful
flashing: Connecting
off: No connection
lit: Connection successful
flashing: Connecting
off: No connection
Input passcode.
"0000"