System Operation - JTS UT-16GT Manual

6. System Operation

Be sure to mute the audio signal of a mixer or amplifier before turning on the receiver and transmitter.
(1) Power on
Turn AF level on the receiver completely counter-clockwise to the minimum level, and switch on the
receiver. As soon as you turn power
the RF
Always it is a good idea to keep "open space" between transmitter and receiver, that will improve RF
reception.
(2) Selecting channel for the receiver and transmitter
1. Use the supplied screwdriver to select a desired channel for the receiver
Both receiver and transmitters are preprogrammed with 16 channels.
2. Make sure the channel of receiver matches that of the transmitter.
3. When 2 or more transmitters and receivers are being used in the same location, they must be set up to
use different channels. If existing channel is being interfered, please change to another non-interference
channel.
signal and AF LED light up to indicate the receiver is ready for operating.
5 6
2 3
4
of the receiver on, the power LED
2
lights red, meanwhile
3
5 6
and transmitters
4
4
.
4
10