Advertisement
Installation Notes
2.1 Monitor angle adjustment
To ensure a healthy and comfortable body posture while using the
monitor, you can adjust the monitor within a range of approximately -
5°~ 15°
2.2
Base, bracket installation and unloading
Please refer to the figure below
to install
a. Mount the bracket to the display
2.3 Monitor Installation
T
1,
urn off the computer and unplug the power cord
2, Connect the signal cable to the signal connector on the back of the computer and rotate the screws at
the ends of the signal cable.
3, Connect the AC output of the power cord to the AC input of the rear case of the monitor and plug the
power cord into the nearest movie jack.
4, Turn on the power switch of the computer and monitor. If there is image on the monitor, you have
successfully installed it. If the monitor has no image, you should check all the cables.
b.Mount the base to the bracket
DVI
DVI
VGA
（optional）
DVI cable
-5°~ 15°
-5° ~ 15°
Please refer to the figure below
to uninstall
a.Press and hold the bracket hook to remove the base b.
Monitor input terminal overview
1, AC port
AC
2, DVI port
3, VGA port
Note: The specific ports and signal cable, please
refer to the actual product.
Remove the stand from the display
6
Advertisement
