Chapter 6 Parameter Settings; Inter-Module Synchronization Setting - Mitsubishi Electric MELSEC iQ-R Series Reference Manual

6
PARAMETER SETTINGS
This section describes the parameter settings required to use the inter-module synchronization function.
6.1

Inter-Module Synchronization Setting

Set the module configuration diagram with the engineering tool, and set the inter-module synchronization settings.
[System Parameter]  "Inter-module Synchronization Setting"  "Inter-module Synchronization Setting"
Operating procedure
"Inter-module Synchronization Setting" window
"Select the Synchronous Target Module" window
"Inter-module Synchronization Setting" window
"Inter-module Synchronization Setting" window
*1 When a project is created with the remote head module, the setting is not available.
6 PARAMETER SETTINGS
34
6.1 Inter-Module Synchronization Setting
1.
Select "Use" for "Use Inter-module
Synchronization Function in System".
2.
Click "Detailed Setting" at "Select Inter-module
Synchronization Target Module".
3.
The modules set in the module configuration
diagram appear. Set "Synchronize" in the
setting field for the synchronization target
module.
4.
Set the inter-module synchronization cycle at
"Fixed Scan Interval Setting of Inter-module
Synchronization".
5.
When writing the parameters, write in both the
system parameters and module parameters.
6.
To use the CC-Link IE Field Network module
on the local station as the synchronization
target module, set Inter-module
Synchronization Master Setting. (For the
module on the master station, the setting is not
*1
required.)