Adjusting The Level Of The Subwoofer(S); Adjusting The Cut-Off Frequency - Sony XDP-210EQ Operating Instructions Manual

Adjusting the level of the
subwoofer(s)
— Sound Control Mode
You can adjust the subwoofer level
independently of the speakers.
1
Press (SOURCE) to select a source (radio,
tape, CD or MD etc.).
2
Press (SOUND) repeatedly until "SUB"
appears.
SUB 1
SUR EQ
3
Rotate/Press (+) or (–) to adjust the
level.
After three seconds, the display goes back
to the normal playback mode.
Tip
To adjust the cut-off frequency of the subwoofer(s), press
(SOUND) for two seconds within theree seconds after
following step 3. The go to step 3 to 4 of "Adjustin the cut-
off frequency."
0
Adjusting the cut-off
frequency
— Crossover Network (CNW)
— Sound Tuning Mode
To match the characteristics of the connected
speakers or subwoofer(s), you can cut the
unwanted high, middle and low frequency
signals entering the speakers or subwoofer(s).
By setting the cut-off frequency (see the
diagram below), the speakers will output only
the most suitable frequency signals so that you
can get a clearer sound image.
Low Pass Filter (Subwoofer)
Cut-off frequency
50 62 78 99 125 157
High Pass Filter (Front, Rear)
Cut-off frequency
78
1
Press (SOUND) for two seconds.
2
Press (SOUND) repeatedly until "CNW"
appears.
CNW Cut off
SUB125Hz
SUR EQ
continue to next page n
Frequency (Hz)
99 125 157 198
Frequency (Hz)
EN
7