Table of Contents
Advertisement
Quick Links
Epoxy resin, good quality tools and a very sharp blade!
WE RECOMMEND HITEC RADIO EQUIPMENT AS USED BY THE
Throttle HS 422 Ailerons HS 625 MG Eleveator HS 645 MG
84 - 88, London Road,
Teynham,
Near Sittingbourne,
Kent. ME9 9QH.
England.
Before starting please check all components
Additional items requires for completion:
Radio gear, motor, prop, tuned pipe/silencer, cyno,
WESTON UK DISPLAY TEAM:
Tel: +44(0)1795 521030
Fax: +44(0)1795 522020
Vat Reg. No 217 2427 83
www.westonuk.co.uk
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Weston UK MAGNUM R
Summary of Contents for Weston UK MAGNUM R
- Page 1 Radio gear, motor, prop, tuned pipe/silencer, cyno, Epoxy resin, good quality tools and a very sharp blade! WE RECOMMEND HITEC RADIO EQUIPMENT AS USED BY THE WESTON UK DISPLAY TEAM: Throttle HS 422 Ailerons HS 625 MG Eleveator HS 645 MG Tel: +44(0)1795 521030...
- Page 2 Parts List uselage Wing Tail fin Tailplane x 2 Aileron servo mount (W18) Elevator Servo mount (D23) Elevator Servo Cover Accessory Packs containing the following; Fueltank Engine mount Throttle wire Wing bolt Engine Mount Bolts + washers Elevator Pushrod inner x 2 Elevator Pushrod joiner Elevator Pushrod insert x 2 Aileron Pushrods x 2...
- Page 3 Wing Place the Aileron mounting tray over the Servo cutout in the wing. Using a felt tip pen, mark the edge of the mount and then cut away the covering film. Using cyno, stick the mounting plate to the wing then screw the servo to the mounting plate. Screw the snaplinks to the Aileron pushrods then attach the pushrods to the servo arm using the swingkeepers, adjust the length of the pushrod accordingly.
- Page 4 Switch Mount the switch harness in the switch hole provided on the side of the fuselage near the receiver (on the opposite side to the exhaust/pipe), ensuring free movement of the switch. Engine mounting nstall engine onto the pre-drilled engine mount and secure with self tapping allen key screws.
- Page 5 Tailplane and Elevator The tailplane is in two halves and must be inserted into the fuselage which has a pre-set anhedral. Once inserted mark the film with a pen along the points at which the film has to be removed. Once removed from fuselage remove film and re-install to ensure good fitment. When happy with the fitment apply gap filling cyano or “wet assemble”...
- Page 6 Diagram 1 - Throttle servo mounting plate, D23 Please use 5 min epoxy and screw to secure elevator servo tray Diagram 2 - Elevator servo Diagram 3 - Elevator pushrod joiner Diagram 4 - Fueltank Assembly details...
Need help?
Do you have a question about the MAGNUM R and is the answer not in the manual?
Questions and answers