Table of Contents
Advertisement
Location of Parts and Operation
Front/Top/Bottom
2
3
1 Lens mount (C-mount)
Attach any C-mount lens or other optical equipment.
Note
The lens must not project more than 7 mm (9/32 inch)
from the lens mount.
1 Lens mount face 2 7 mm (9/32 inch) or less
2 Auxiliary holes (Top)
3 Reference holes (Bottom)
These precision screw holes are for locking the camera
module. Locking the camera module into these holes
secures the optical axis alignment.
Four screw reference holes of 3 can be used as the
tripod adapor screw holes, too. Screw the tripod
adaptor VCT-ST70I into the four screw holes when
you use a tripod.
XCD-V50CR
XCD-V50
1
3
Rear Panel
4
6
4 IEEE1394b connectors
Connect the IEEE1394b cable (supplied) to this
connector.
5 Pilot lamp
This lamp indicates the camera module operation
states:
OFF: Camera power OFF
Green: Camera power ON/Video signal output OFF
Orange: Camera power ON/Video signal output ON
6 TRIG IN (Trigger)/Exposure OUT connector
Connect the trigger signal generator (trigger output
connector) to this connector.
When the external trigger function is set to OFF, a
signal indicating the exposure time is output.
Pin No.
Signal
1
EXPO-OUT
2
TRG-GND
3
TRG-IN
4
NC
Overview
5
1
4
2
3
6
Advertisement
Table of Contents
