Sony DCR-VX2000E Operating Instructions Manual page 110

Dubbing only desired scenes
– Digital program editing
Preparation 2: Setting the VCR
to operate by infrared rays
emitter
To edit using the VCR, send the control signal
by infrared ray to the remote sensor on the
VCR. When you connect using the A/V cable,
this procedure is required.
(1) Set the POWER switch to VCR on your
camcorder.
(2) Turn the power of the connected VCR on,
then set the input selector to LINE.
When you connect a video camera recorder,
set its POWER switch to VCR.
(3) Press MENU to display the menu.
(4) Turn the SEL/PUSH EXEC dial to select
, then press the dial.
(5) Turn the SEL/PUSH EXEC dial to select
EDIT SET, then press the dial.
(6) Turn the SEL/PUSH EXEC dial to select
CONTROL, then press the dial.
(7) Turn the SEL/PUSH EXEC dial to select IR,
then press the dial.
Set the IR SETUP code
(8) Turn the SEL/PUSH EXEC dial to select IR
SETUP, then press the dial.
(9) Turn the SEL/PUSH EXEC dial to select the
IR SETUP code of your VCR, then press the
dial.
See "About the IR SETUP code " on page
112.
110
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)