Use Of Wireless Remote Control - York MHC-MHH/BOC-BOH 07 Owner's Manual

USE OF WIRELESS REMOTE CONTROL

PRIOR TO OPERATION
Prior to operating your air conditioner, make sure
that:
• The indoor unit is properly plugged into the electrical
socket. (Except for multisplit models).
• STAND-BY indicator on the unit's display is lit, meaning
that the air conditioner is ready to accept your remote
control commands.
• The red tab protecting the remote control batteries has
been removed.
• For clock setting see page 16.
Attention:
• Aim at the infrared signal receiver on the room air conditioner when operating.
• The remote control signal can be received at a distance of up to about 8 m.
• Be sure that there is nothing between the remote control and the signal receptor.
• Do not drop or throw the remote control.
• Do not place the remote control in a location exposed to direct sunlight, or next to a heating unit,
and/or other heat source.
• Do not expose the air conditioner signal receiver to a strong light such as fluorescent lamp or sunlight.
REMOTE CONTROL BATTERY CHANGE
• Remove the batteries from the remote control as shown.
• Use two 1.5 volt size AAA batteries
• Perform reset operation by pressing TIMER UP buttons,
TIMER DOWN button, TIMER SET button and TIMER
CLEAR button.
REMOTE CONTROL HOLDER (DESK TYPE)
Use the remote control holder when unit is not in
use. Remote control can be slipped in or out its
holder.
WIRELESS REMOTE CONTROL
PUTS ALL FUNCTIONS AT YOUR
FINGERTIPS
˚C
— — TEMP —
SET
TIMER
˚C
˚C
+
MODE
+
CLEAR
—
11
HIGH WALL