Sony Handycam DCR-TRV240 Operating Instructions Manual page 86

Dubbing only desired scenes – Digital program editing (on tapes)
Erasing the program you have set
Erase OUT first and then IN from of the last program.
(1) Turn the SEL/PUSH EXEC dial to select UNDO, then press the dial.
(2) Turn the SEL/PUSH EXEC dial to select EXECUTE, then press the dial.
To cancel erasing
Select RETURN in step 2.
Erasing all programs
(1) For DCR-TRV240:
(2) Select ERASE ALL in the menu settings. Turn the SEL/PUSH EXEC dial to
To cancel erasing all programs
Select RETURN in step 2.
To cancel a program you have set
Press MENU.
The program is stored in memory until the tape is ejected.
Notes
•Digital program editing does not work when PB MODE is set to
settings.
•You cannot operate recording during Digital program editing.
You cannot set IN or OUT to the following portions of the tape:
– A blank portion of the tape
– A portion recorded in a system other than Digital8
The total time code may not be displayed correctly in the following cases:
– The tape is not recorded in the Digital8
– There is a blank portion between IN and OUT on the tape.
86
The last set program mark flashes, then the setting is canceled.
Turn the SEL/PUSH EXEC dial to select VIDEO EDIT, then press the dial.
For DCR-TRV340/TRV740/TRV840:
Select VIDEO EDIT in the menu settings. Turn the SEL/PUSH EXEC dial to
select TAPE, then press the dial.
select EXECUTE, then press the dial.
All the program marks flash, then the settings are canceled.
system.
/ in the menu