Table of Contents
Advertisement
Key to Machine Parts (Page 2)
1
Control panel
2
Water tank lid
3
Hot water/steam knob
4
Seat for accessories
5
Water tank
6
Cup holder rest
7
Water recovery tray + grill
8
Brew unit
9
Steam wand (Pannarello)
10 Power cord
11 Pressurized fi lter holder
12 Ground coff ee measuring scoop
13 Ground coff ee fi lter
(single piece for 1 or 2 coff ee(s))
14 Coff ee pod fi lter adapter
15 Coff ee pod fi lter
16 ON/OFF button
17 "Machine on" indicator light
Light ON = the machine is on
Light OFF = the machine is off
18 Coff ee brew button
19 Coff ee/water - "Machine ready" indicator light
Light ON = OK for coff ee brewing / hot water dispensing
Light OFF = temperature is low for coff ee brewing / hot
water dispensing
20 Steam button
21 "Steam ready" indicator light
Light ON = OK for steam dispensing
Light OFF = temperature is low for steam dispensing
4
INSTALLATION
For your own and other people safety, carefully follow
the "Safety Regulations" indicated in section 3.
4.1 Packaging
The original packaging has been designed and manufactured
to protect the machine during transport. We recommend keep-
ing the packaging material for possible future transport.
4.2 Installation Instructions
Before installing the machine, read the following safety in-
structions carefully:
• Place the machine in a safe place;
• Make sure children cannot play with the machine;
• Do not place the machine on hot surfaces or near open
fl ames.
The coff ee machine is now ready to be connected to the electric
network.
Note: We recommend washing the components
before using them for the fi rst time and/or af-
ter they have not been used for a certain period of time.
4.3 Water Tank
• (Fig.1A) - Remove the lid from the water tank (2) by lifting
it.
• (Fig.1B) - Remove the water tank (5).
Note: The machine accessories are placed on
the water tank's (5) side.
• (Fig.2) - Rinse the tank and fi ll it with fresh drinking water
taking care not to overfi ll.
Fill the tank only with fresh, non-sparkling,
drinking water. Hot water or any other liquid
may damage the tank. Do not operate the machine
without water. Make sure there is enough water in the
tank.
• (Fig.3) - Insert the water tank making sure that it has
been properly repositioned in its former seat and then
reposition the lid (2).
Make sure that the tank is fully inserted in the
machine by pressing it gently up to its limit stop
(THE REFERENCE MARK SHOWN IN FIG. 4 SHOULD BE
COMPLETELY VISIBLE). This is to avoid water leaks from
its bottom.
4.4 Machine Connection
Electric power may be very dangerous! It is
therefore necessary to strictly follow the safety
regulations. Do not use faulty power cords. Faulty cords
and plugs must be replaced immediately by Authorised
Service Centres.
The voltage of the appliance has been pre-set by the manu-
facturer. Check that the voltage matches the indication on the
data plate at the bottom of the appliance.
• Make sure that the ON/OFF button (16) is NOT pressed be-
fore connecting the machine to the electric network.
• Insert the plug into a wall socket with suitable power volt-
age.
• 17 •
Hide quick links:
Advertisement
Table of Contents
