Specifications - Cisco CWDM-OADM 1 Series Installation Notes

Connect the single pair fiber-optic cables from the CWDM GBIC transceivers or CWDM SFP
Step 4
transceivers (Tx/Rx; up to eight channels) to the 8-channel multiplexer/demultiplexer module equipment
connectors (Tx/Rx; up to eight wavelengths).
Note
Note
Connect the network backbone single pair fiber-optic cable to the multiplexer/demultiplexer
Step 5
NETWORK connector on the OADM module.
Step 6 If you are planning to monitor your network with an optical power meter or an optical spectrum analyzer,
connect your meter or analyzer to the MONITOR port on the OADM.

Specifications

Table 5
modules.
modules.
Table 5
Item
Physical Characteristics
Dimensions
Weight
Environmental
Operating temperature
Storage temperature
78-16565-02
CWDM GBIC transceivers are equipped with SC connectors. To make connections to the LC
connectors on the multiplexer/demultiplexer device, you must use an LC to SC patch cable
(Cisco part number CAB-SM-LCSC-1M= [1 meter cable], CAB-SM-LCSC-5M= [5 meter
cable], or an equivalent patch cable).
Connect the Tx ports to the Rx ports and the Rx ports to the Tx ports to ensure that the system
operates correctly.
lists the environmental specifications for the CWDM OADM and multiplexer/demultiplexer
Table 6 lists the optical specifications for the CWDM OADM and multiplexer/demultiplexer
CWDM Passives Physical and Environmental Specifications
Specification
8.35 x 1.75 x 8.7 in. (212 x 44 x 221 mm)
1.5 lbs. (0.68 kg)
32 to 140 ºF (0 to 60ºC)
-40 to 185ºF (–40 to 85ºC)
Cisco CWDM Passive Optical System Installation Note
Specifications
25