Removing The 10-Gigabit Xfp Transceiver Module - Cisco DWDM-XFP Series Installation Notes

c.
d.
Figure 3
Network interface

Removing the 10-Gigabit XFP Transceiver Module

The XFP transceiver module is a static-sensitive device. Always use an ESD wrist strap or similar
Caution
individual grounding device when handling XFP transceiver modules or coming into contact with
modules.
If you are removing an XFP transceiver, follow these steps:
Disconnect the network interface cable from the XFP transceiver module connectors. Immediately
Step 1
reinstall the dust plug in the fiber-optic cable LC connector.
Pivot the XFP transceiver module bail clasp up to release the XFP transceiver module from the socket.
Step 2
(See
Slide the XFP transceiver module out of the socket. Pivot the bail clasp down and immediately install
Step 3
the dust plug in the XFP transceiver module optical bores. (See
Immediately place the XFP transceiver module in an antistatic bag.
Step 4
OL-24246-01
Remove the dust plugs from the XFP transceiver module optical bores.
Immediately attach the network interface cable LC connectors to the XFP transceiver module. (See
Figure 3.)
Cabling a 10-Gigabit XFP Transceiver Module
XFP transceiver
LC connector
cable
Figure 4, top view.)
Removing the 10-Gigabit XFP Transceiver Module
1
2
L IN K
A C T
IV E
L IN K
A C T
IV E
Cisco 10-Gigabit XFP Transceiver Modules Installation Note
Figure 4, bottom view.)
19