Fiber-Optic Cleaning Information - Cisco WS-G5484 Installation And Specification Manual

Fiber-Optic Cleaning Information

Figure 14
1
Attaching the Mode-Conditioning Patch Cord
Perform the following steps to attach the mode-conditioning patch cord:
Attach the patch cord to the SC-type receptacle on the GBIC module
Step 1
on the SFP module
Attach the network ends of your patch cord to the appropriate 1000BASE-X equipment in your building
Step 2
cable plant.
Note
If you are attaching cables from CWDM GBIC modules or SFP modules to the Cisco optical add-drop
(OADM) modules, see the documentation for the OADM modules.
This completes the procedure for attaching a mode-conditioning patch cord.
Fiber-Optic Cleaning Information
For information about cleaning fiber-optic cable connectors and receptacles, see the
Cleaning Procedures for Fiber-Optic Connections document.
procedures and equipment required to properly clean fiber-optic connections. Also see the
Cleaning Issues for Fiber-Optic Connections
Gigabit Interface Converter (GBIC) Module and Small Form-Factor Pluggable (SFP) GBIC Module Installation Information and Specifications
22
RJ-45 Port and Copper SFP RJ-45 Gigabit Ethernet Port Cabling
C is c o 7 2
0 1
RJ 45 EN
LI NK /A CT
V
SF P
RJ 45
EN
GE 0/ 0
GE 0/ 1
1
RJ-45 connector
(Figure 6).
Ensure that you connect the TX and RX ports on one end of the patch cord to the RX and TX
ports (respectively) on the other end. Connect TX to RX and RX to TX.
CO NS OL E
LI NK /A CT
V
LI NK /A CT
TX
SF P
V
RX
LI NK /A CT
SF P
V
TX
SF P
RX
M NG M NT
US E ON LY
GE 0/ 2
GE 0/ 3
AU X
FE 0/ 0
LI NK
2
2 Copper SFP module RJ-45 connector
It provides detailed illustrations and photos of
document.
0
FE
(Figure 5) or the LC-type connector
Inspection and
Compressed Air
OL-5067-08