Exchange Fuse On The 12 V Vehicle-Connection; Error Tracing; Maintenance And Care; Service - AEG KD 7.0 Operation And Safety Notes

Operation / Error tracing / Maintenance and care / Service / Warranty
Exchange fuse on the 12 V
 
vehicle-connection
j 
R elease (and remove) the knurled ring
turning it against the clockwise direction.
j 
R emove the defective fuse and replace it
with a new one, max. 10 amps.
j 
S crews the knurled ring
turning it in the clockwise direction

Error tracing


the manometer display

C heck, if the12 V vehicle- connection
inserted completely and correct and voltage
is on. (POWER-LED on 12 V vehicle-connec-
tion shines).
10

C heck, if the POWER-LED on 12 V vehicle-
connection shines. If not, check the fuse
10
of the 12 V vehicle-connection
the fuse on the 12 V-socket of the vehicle.
Despite switched on On- / OFF-switch
(in position ) the device does not start
the pumping procedure.

T urn the ignition key / ignition into the first
position (do not start the engine)
the device does not finish the pre-set
pump procedure automatically.

E nsure that you have followed the operating
instructions correctly.

E nsure that you have pre-set the correct
value.
the power cable and / or the 12 V vehicle-
connection gets hot.

D anger of short circuit - Disconnect the
device immediately from the circuit.
the manometer-display
wrong value or is not readable.

E nsure that the device has measured the ac-
tual tyre pressure, (see chapter „Tyre pressure
check").
, by
11
again firmly, by
11
does not shine.
2
is
10
as well as
10
3
shows the
2

P ull off the 12 V vehicle- connection
at least 5 seconds from the 12 V-socket of the
vehicle and remove the valve connection
from the vehicle. Wait until the manometer-
display shows 0,0 again. Re-start the
2
procedure again.
the pump procedure is running, but the
tyre does not inflate.

E nsure that the valve-connection
correctly on the valve of the vehicle.

E nsure that the tyre does not have a puncture.

Maintenance and care


The device is maintenance-free.
WarnIng!
Always separate electrical de-
vices from the power supply, before you carry
out service etc.
j 
S witch off the device .
j 
P ull of the 12 V vehicle connection
the 12 V-socket of your vehicle.
j 
C lean the device with a dry cloth. Do not use
solvents or other aggressive detergents
under any circumstances.

Service


WarnIng! Leave the repair of the
device to qualified technical personnel to
repair. Thus the safety of the device is guaran-
teed and maintained.
Leave the exchange of the
WarnIng!
plug or the connecting cable always to quali-
fied technical personnel. Thus the security of
the equipment is guaranteed and maintained.

Warranty


The general guarantee conditions refer to
production and material defects.
for
10
15
is fixed
15
from
10
GB 15