Commissioning; Specifying The First Direction Decision; Direction Decision - Pepperl+Fuchs PGV...-F200...-R4-V19 Series Manual

PGV...-F200/-F200A...-R4-V19

Commissioning

4 Commissioning
4.1

Specifying the First Direction Decision

To ensure that the read head does not report any error messages after being switched on, a
direction decision must be specified. You can control the direction decision via the
INPUT_SELECTION_DIR_RIGHT and INPUT_SELECTION_DIR_LEFT inputs. See chapter
3.3.
INPUT_SELECTION_DIR_LEFT
INPUT_SELECTION_DIR_RIGHT
Figure 4.1
Direction decision via protocol
If a decision on the direction to take is sent to the read head via a protocol, the input signals are
ignored until the read head is reset. See chapter 5.1.
4.2

Direction Decision

The read head has several ways of following colored tapes and Data Matrix code tapes
depending on the parameterization. Depending on the input signal, the read head follows the
right-hand, the left-hand, or the better lane.
Direction Decision via Input Signal
0
0
1
1
Table 4.1
32
Direction decision Error 5
≥ 20 ms
1
0
1
0
Direction Decision
0 No lane is selected
Error code 5
1 Follow right-hand lane
0 Follow left-hand lane
1 Colored tape: follow lane with better quality
Data Matrix code tape: follow lane with more detailed position information
Data Matrix tag: no significance
Left Right Left Error 5
t