Table of Contents
Advertisement
Overheating protection
All the induction coils and cooling ele-
ments for the electronics are fitted with
an overheating protection mechanism.
Before the induction coils and/or cool-
ing elements get too hot, the overheat-
ing protection mechanism cuts in in one
of the following ways:
Induction coils
– The set power level is reduced.
– The Tepan Yaki zone switches itself
off automatically. flashes altern-
ately with in the timer display.
You can use the Tepan Yaki zone again
as usual when the fault code has gone
out.
Cooling elements
– The set power level is reduced.
– The Tepan Yaki zone switches itself
off automatically.
The affected Tepan Yaki zone can only
be used again as usual once the cool-
ing element has cooled down to a safe
level.
The overheating protection may be ac-
tivated under the following circum-
stances:
– Fat or oil is being heated on a high
power level.
– Insufficient ventilation to the under-
side of the Tepan Yaki.
– A hot Tepan Yaki zone being
switched on after an interruption to
the power supply.
If, despite removing the cause, the
overheating protection mechanism trig-
gers again, contact Miele Service.
Safety features
31
Advertisement
Table of Contents
